Shark Anti-Hair Wrap & DuoClean Cordless Vacuum User Guide

June 7, 2024
Shark

Shark Anti-Hair Wrap & DuoClean Cordless Vacuum User Guide

REACH ANYWHERE

Press the Flexology Lock Release button to lower the angle of the wand to increase your reach.

STORE ANYWHERE

Press the Flexology Lock Release button and fold the handheld vacuum forward. To vacuum, lift up the handheld vacuum, until the wand locks in place.

diagram

EMPTYING THE DUST CUP

  1. To empty dust cup, first disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up on the handheld vacuum.                                     

  2. Position dust cup over a trash bin and slide the lid release button forward.

WHAT’S INSIDE:

  • A. Handheld Vacuum
  • B. Motorised Floor Nozzle
  • C. Flexology Wand
  • D. Upholstery Tool
  • E. Crevice Tool
  • F. Dusting Brush
  • G. Anti-Allergen Dusting Brush (Certain Models only)
  • H. Lithium-Ion Battery (2x Certain Models only)
  • I.  Lithium-Ion Power Pack Charger
  • J.  Dual Charging Dock (Certain Models only)
  • K. Motorised Pet Brush (Certain Models only)

a drawing of a person

ASSEMBLY

For additional parts and accessories, visit sharkaccessories.eu

POWER SETTINGS

OFF
Slide switch to the top to turn off power. To begin vacuuming, slide switch to the appropriate setting.

HARD FLOOR SETTING
The brush-roll spins slowly to clean hard floors and low-pile area rugs.

CARPET SETTING
The brush-roll spins faster to pick up debris below the surface of your carpets.

BOOST MODE
For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.

LITHIUM-ION POWER PACK

In Use

Charging

**Battery Indicator Lights

NOTE:** The LITHIUM-ION Power Pack battery comes partially charged. Charge fully before first use, then run the battery down until it is completely out of power. This will condition the battery so the LED indicators will work properly.

CHARGING

diagram
To put the vacuum in storage mode, press the Unlock latch while folding the handheld vacuum forward until the wand clicks and locks. Plug the charger into the charging port on the handheld vacuum.

diagram, engineering drawing
To remove the battery, squeeze the Battery Release Button and slide backwards. Plug the charger into the charging port on the battery.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals