MPOW Auto-Lock Wireless Car Charger Mount User Manual
- June 7, 2024
- MPow
Table of Contents
AUTO-LOCK WIRELESS CAR CHARGER MOUNT
MPOW CAR PHONE MOUNT
Package
Working Process
A. Power Indicator
B. Precise Alignment
C. Extendable Arms
1. Tap the Release Button on either
side and the arms will open automatically.
2. Once the phone is in, the arms will lock automatically.
3. After removing the phone, tap the Release Button on either side and the
arms will close automatically.
D. Charging
Charging/Fast Charging: Red light stays on
Error: FOD (Foreign Object Detection)/overvoltage protection/overtemperature protection/overcurrent protection
Assembly
Installation
1. Make sure the clip is in the loosened state.
2. Insert the clip into the air vent louvers.
3. Toggle the lock lever to fix.
4. Adjust the angle by rotating the 360° ball joint.
Notification
1. Not recommended to install the mount on rough, dirty, and curved surfaces.
2. The wireless charger only works with phones that support wireless
charging.
3. When using the QC2.0/QC3.0 car charger, the charging efficiency can reach
7.5W or 10W.
4. Please adjust the support foot to properly align your phone and fix it
firmly.
5. With over-temperature protection, the product may stop working if the
temperature exceeds 50°C.
6. Do not expose it to direct sunlight for a long time, as high temperatures
will weaken the suction cup.
7. To renew the stickiness of the suction cup, just rinse it with water and
let it air dry.
8. Please use an adapter of 5V 2A or above for normal wireless charging.
FCC Statement
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
www.xmpow.com |
support@xmpow.com
MPOW TECHNOLOGY CO., LTD
Copyright © MPOW Inc. All rights reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>