imc Mobile Hand Wash Unit User Manual

MOBILE HAND WASH UNIT
INSTALLATION AND USER MANUAL
PLEASE LEAVE WITH OPERATOR

MOBILE HAND WASH UNIT ­ F63/503

Imperial Machine Company Limited
Unit 1, Abbey Road
Wrexham Industrial Estate
Wrexham LL13 9RF
Tel: +44 (0)1978 661155
Fax: +44 (0)1978 729990
Spares Fax: +44 (0)1978 667759
E-mail: service@imco.co.uk
E-mail: sales@imco.co.uk
Website: www.imco.co.uk

MOBILE HAND WASH UNIT

INTRODUCTION
Congratulations on your purchase of the IMC Mobile Hand Wash Unit. Thoughtfully designed to allow the users to wash their hands. This manual outlines the installation, operation procedures relevant to this unit.

Guarantee
The Mobile Hand Wash unit is guaranteed by IMC for 1 year from the date of purchase from IMC, or from one of its stockists, dealers or distributors. The guarantee is limited to the replacement of faulty parts or products and excludes any consequential loss or expense incurred by the purchaser. Defects that arise from faulty installation, inadequate maintenance, incorrect use, or fair wear and tear are not covered by the guarantee.

The guarantee applies in this form to installations within the United Kingdom.
Please observe these instructions carefully.

Delivery
The packaged unit contains:

IMC MOBILE HAND WASH UNIT:
Fully Assembled Hand Wash Unit
Splashback Panel
Paper Tower Dispenser
Soap Dispenser|

1

1

1

1

---|---
Water container 20L – Natural| 2
Instruction Booklet| 1

Please notify LINCAT on the day of receipt if anything is missing or damaged.

UK: 01522 875555

Check that the correct machine has been supplied. The data plate is located on the rear of the unit.

DIMENSIONS

SPECIFICATION

PRODUCT FEATURES

INSTALLATION

These instructions contain important information designed to help the user obtain the maximum benefit from their investment in an IMC Mobile Hand Wash Unit.

Please read them carefully before starting work and consult with your distributor/supplier in the event of any queries.

Be sure to leave this Instruction Manual with the user after the installation of the machine is complete.

Procedure
WARNING
The following table shows the weight and the minimum quantity of people required to lift each unit:

| Net Weight| Quantity of People
---|---|---
IMC Mobile Hand Wash Unit| 27.4 kg| 2

Before using the hand wash; remove all packaging and ensure that the unit is checked over for damage, any damage must be reported to the carrier or distributor/supplier immediately.
Remove any protective plastic coating on the unit.
Do not be alarmed if water is present in the tanks or pipes of the unit, this is normal and only a mere consequence of the testing procedures.

Location
The Mobile Hand Wash Unit is only suitable for use where there is no risk for the unit to be adversely affected by its surrounding environment.
The unit must be stationed on a flat surface capable of safely supporting the weight of the unit when fully laden with water.
The unit it is fitted with a handle on the back to assist when moving.

Commissioning
Remove the front panel by unscrewing the black knob on the front of the unit, tilt the panel backward and pull upwards away from the unit at an upward angle. This will enable the operator to gain access to the clean and waste water containers inside the unit.
Once the front panel has been removed, lift out the suction hose from the clean water container and remove the water container. Note the water container can hold a maximum of 20 liters. Ensure when refitting the water container that the suction hose has been placed at the bottom container.

We advise that you operate the foot pump and pass water through the unit before refitting the front panel. To prime the pump ready for operation and pass water through the unit; place your foot inside the housing above the pump. Depress the foot pump several times until water is seen coming out of the spout located above the sink on the unit.

Once all of the above steps have completed and the front panel has been refitted, your Mobile Hand Wash Unit should now be ready for operation.

Emptying / Refilling
Once the unit has completed its total number of operations, the wastewater container will need emptying and the clean water tank refilled.

To empty the wastewater container; remove the front panel. The waste-water pipe can now be removed and the container can be slid out of the unit and emptied appropriately.

To re-install the wastewater container, follow the above steps in reverse.
To refill the clean water container, follow the steps outlined in the commissioning section.
Cleaning
Clean the externals of the unit as required; using a damp cloth and an appropriate cleaning product.
DO NOT USE CLEANING MATERIALS CONTAINING ABRASIVES OR BLEACHES.

SPARE PARTS

Spare Parts List

Ordering Spare Parts
In the event that spare parts or accessories need to be ordered, please always quote the SERIES AND SERIAL NUMBER of the machine. This is to be found on the rating plate located near the supply cable if applicable or at the rear of the appliance.
For installations outside the UK please contact your supplier.

For information on IMC spares and service support (if applicable), please call IMC on +44 (0)1978 661155. Alternatively, contact us via email:

IMC Service Desk E-mail: service@imco.co.uk
IMC Spares Desk E-mail: spares@imco.co.uk

Imperial Machine Company Limited
Unit 1, Abbey Road
Wrexham Industrial Estate
Wrexham LL13 9RF
Tel: +44 (0)1978 661155
Fax: +44 (0)1978 729990
Spares Fax: +44 (0)1978 667759
E-mail: service@imco.co.uk
E-mail: sales@imco.co.uk
Website: www.imco.co.uk

References

• IMC | Lincat Catering Equipment

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>