digitech Turntable In Built Speakers User Manual
- June 7, 2024
- Digitech
Table of Contents
digitech Turntable In Built Speakers User Manual
Box Contents:
Product Diagram:
Operation:
Mains Connection:
Connect the mains power adaptor to a standard 240VAC wall socket and connect
the plug to the socket of the turntable.
Amp Connection:
Connect audio plugs to Alert input on your mixer or amplifier:
- Red plug into R/H channel input.
Playing Record:
-
Place the record of your choice on the turntable. If it is a 45rpm, do
Not forget to place the adapter on the record spindle. -
Choose the desired playing speed using the Speed select switch between 33.3, 45 and 78rpm.
-
Turn on the Rotary Power Switch.
-
Release the tone arm lock.
-
Push in the arm with your hand lightly.
-
Place the stylus vertically over the first track of the record the turntable will start turning automatically.
-
Put down the cartridge slowly to the record then the turntable will play.
-
When a record comes to the end, the turntable will stop automatically if the Auto-stop switch is in the ON position. If the switch is in the off position, then it will be suitable for Long Play records.
Note:
- Lift up the tone arm and put it on the rest.
- Replace the protective cap on the stylus and close the tonearm lock.
- Turn off power at mains.
Replacing The Stylus:
-Refer to the figures 1-8
Installing A New Stylus:
-Refer to the figures 5 & 6
NOTES
We advise you to clean your records with an anti-static cloth to gain maximum
enjoyment from them and to make them last.
We would also point out that for the same reason your stylus should be replaced periodically {approximately every 250 hours)
Dust the stylus from time to time using a very soft brush dipped in alcohol (brushing from back to front of the cartridge)
WHEN TRANSPORTING YOUR RECORD PLAYER DO NOT FORGET TO:
- Replace the protective cap on the stylus.
- Put the rest clip into the pick-up arm.
Safety:
- Do not open the case of the turntable to avoid damage and injury.
- Keep the turntable away from high temperatures as it may cause damage to the turntable and speakers.
- Do not expose the turntable to water, moisture or liquids to prevent the unit from damage.
- Make sure the mains power adaptor is connected correctly to a standard 240VAC wall socket.
- If using a replacement or third party mains power adaptor; make sure the voltage and current match the specifications as 5VDC, 1.
Specifications:
Turntable Drive System : Belt Drive
Cartridge Type : Ceramic Stereo Stylus
Inputs : USB, SD
Output : 1 x External Speaker, 1 x RCA (L & R)
Speed : 33/45/78RPM
Speakers : 2 x 3W
Frequency Response : 160Hz-14KHz
USB/SD Capacity : Up to 32GB
Power : 5VDC, 1 A
Dimensions : 430(W) x 350(0) x 120(H)mm
Distributed by:
TechBrands by Electus Distribution Pty. Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
Ph: 1300 738 555
Int’I: +61 2 8832 3200
Fax: 1300 738 500
www.techbrands.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>