KOHLER Heated BubbleMassage air bath with Bask User Manual

June 7, 2024
Kohler

KOHLER

KOHLER Heated Bubble Massage air bath with Bask

product

Features

  • Bask® heated surface creates spa-like relaxation with soothing warmth on your back, shoulders and neck.
  • Three heat settings allow you to customize the surface temperature.
  • 118 to 122 airjets release thousands of heated bubbles that surround and support the body in a warm massage.
  • Purge cycles remove residual water from air channels after use to keep the system clean.
  • Variable-speed blower lets you adjust massage intensity to 18 levels.
  • 16″ depth offers a deep soaking experience.
  • Integral lumbar support on both ends.
  • Bottom surface manufactured with textured appearance.
  • Wide ledge on one side is ideal for deck-mount faucet and/or hand shower.
  • Center drain.
  • Straight shroud.

Material: Acrylic.

Technology

  • Bath includes auto purge (after bath drains) and manual purge cycles to remove residual water and keep system clean.
  • Auto-shutoff timer on blower allows users to enjoy Heated Bubble Massage™ experience for 60 minutes before turning off.
  • Built-in 60W electric heater included to keep bath surface warm.
  • User interface: two separate electronic keypad controls for Heated Bubble Massage™ and Bask®.

Installation

  • Freestanding design creates a striking focal point in your bathing area.
  • PureFlo™ drains are not recommended for a deck-mount faucet installation.
  • Remote blower motor installation required (relocation kit is included).
Recommended Products/Accessories

K-7265 Clearflo Bath Drain
K-24916 Wireless Music Kit
K-37383 30″ Rough-in Cable Bath Drain
K-37386 rough-in cable drain, PVC, 30″ cable

Codes/Standards

ASME A112.19.7/CSA B45.10
CSA B45.5/IAPMO Z124
ASTM E162
ASTM E662
UL 1795
CSA C22.2 No. 218.2
Greenguard UL 2818 – Gold

Five-Year Limited Warranty: See website for detailed warranty information.

Overview

image

Required Electrical Service
Two dedicated circuits required, protected with Class A Ground-Fault Circuit- Interrupter (GFCI) or Residual Current Device (RCD).

Technical Information

All product dimensions are nominal.

Installation:   Freestanding
Basin area, bottom:   40-5/16″ x 22-1/2″ (1024 mm x 572 mm)
Basin area, top:   49-3/8″ x 22-7/8″ (1254 mm x 581 mm)
Weight: 160 lbs (72.6 kg)
Minimum floor load:   54 lbs/ft² (263.7 kg/m²)
Water depth: 18″ (457 mm)
Water capacity: 60 gal (227.1 L)
Template: Footprint, 1364289, not required, not included
Electrical component rating:

Blower: 120 V, 10 A, 60 Hz
Heated Surface: 120 V, 0.5 A, 60 Hz
Heater: 120 V, 5 A, 60 Hz

Notes:

  • Measure your actual product for rough-in details.
  • Install this product according to the installation instructions.
  • The hot water supply should be 70% of the capacity of the bath or greater. Installations will vary.
  • Provide one grounded electrical outlet within 24″ (610 mm) of each component.
  • This bath is designed for freestanding installation only.
  • If installing a rim-mount faucet, make sure there is no interference above or below the deck before drilling any holes.

1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications. For the most current Specification Sheet, go to www.kohler.com
4-25-2019 20:08 – USKOHLER

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals