ONKYO Av Receiver / Ampli-Tuner Audio-Video Installation Guide
- June 7, 2024
- ONKYO
Table of Contents
ONKYO Av Receiver / Ampli-Tuner Audio-Video Installation Guide
ch System
- Front Speakers
- Front Speakers
- Center Speaker
- Surround Speakers
- Surround Speakers
- Powered Subwoofer
- Surround Back Speakers
- Surround Back Speakers
Refer to the instruction manual available on our website to install and
connect speaker systems other than 7.1 ch.
Please visit: top
[PDF]
Install & Connections
Installation & Raccordements / Instalación y conexiones
Refer to the instruction manual available on our website to install and
connect speaker systems other than 7.1 ch.
Please visit: top
[PDF]
Initial Setup with Auto Start-up Wizard
To redo the initial setup
7. Miscellaneous”- “ 4.Initial Setup”
-
Used during Initial Setup
-
Connect speakers with 4 Ω to 16 Ω impedance. If any of the connected speakers have an impedance of 4 Ω or more to less than 6 Ω, after completing
“Initial Setup”, you need to make some settings in the Setup menu. Press on the remote controller, select “2. Speaker” – “1. Configuration” and set
“Speaker Impedance” to “4ohms “. -
Make sure the exposed wires of the speakers do not stick out of the speaker terminals when connecting. If the exposed wires of the speakers touch the
rear panel or the + and – wires touch each other, the protection circuit will be activated. -
Choose an HDMI IN jack on the TV that supports ARC when connecting. Settings are required to use the ARC function. Select “Yes” for “ARC Setup” in
“Initial Setup”. -
: If you connect this unit to the network using wired LAN, connect an LAN cable to the ETHERNET port.
-
Switch the input on the TV to that assigned to the unit. Complete the Initial Setup according to the guidance displayed on the screen.
Enable HDMI CEC & HDMI Standby Through function: If you selected “No, Skip” in “ARC Setup” of “Initial Setup”, after completing “Initial Setup”, it is necessary to press the button on the remote controller and execute “5.Hardware” – “1.HDMI” setting.
Tips Troubleshoot your remote control
The remote control may have switched to the mode for controlling ZONE 2. While holding down MODE, press MAIN until the remote indicator fl ashes once to switch it to the mode to control the main room.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>