WAREHOUSE-LIGHTING Adjustable Linear High Bay Instruction Manual
- June 3, 2024
- Warehouse Lighting
Table of Contents
WAREHOUSE-LIGHTING Adjustable Linear High Bay
INSTALLATION INSTRUCTIONS
Wire Guards:(purchase seperately)
To attach wire guards to the luminaire, snap onto the adjustable head overtop
of the lenses.
Light DirectionAdjustment:
After the fixture is installed, adjust the lighting direction of the module
according to your needs (145° maximum adjustment from left to right).
Wiring Diagram
For dimming wires, use class 1 wiring methods. Cap dimming wires (separately) if not used.
CAUTION:
- Read all instructions before starting installation.
- This product must be installed in accordance with the applicable installation codes by a qualified electrician familiar with the construction and operation of the product and the hazards involved.
- Disconnect power at circuit breaker of fuse before starting installation.
- To avoid injury, wear gloves during installation.
- To reduce the risk of electrical shock and product damage, do not install this luminaire during rain or other storms.
- Do not test luminaire using an electric generator before installation.
Instructions
Chain Mount:(included)
To suspend the highbay luminaire from chains, attach the enclosed v-hooks to
the holes on the end caps. Attach the chain to a secure, stationary structure,
and use the spring clips on the end to attach the chain to the v-hooks. Choose
the appropriate knock out, and wire the fixture in accordance with proper
code. 
Cable Mount:(purchase seperately)
To suspend the highbay luminaire from cables, slide the button stop attached
to the end of the cable kit through the hole in the end cap. Then, slide the
rectangular plate installed on the cable through the same hole. Attach the
cable to a secure, stationary structure. Use the spring slide to adjust the
height. Choose the appropriate knockout, and wire the fixture in accordance
with proper code.
Surface Mount:(purchase seperately)
To surface mount the highbay luminaire, bolt the fixture brackets to the
ceiling or rail (Figure 1). Once the brackets have been properly secured,
attach the luminaire using the screws provided (Figure 2). Choose the
appropriate knockout, and wire the fixture in accordance with proper code
.
Pendant Mount:(purchase seperately)
To pendant mount the highbay luminaire, mount the fixture brackets to 1/2”NPS
(Figure 1). Once the brackets have been properly secured, attach the fixture
using the screws provided (Fixture 2). Choose the appropriate knockout, and
wire the fixture in accordance with proper code. Secure the cover plates to
the bracket using the screws provided.
Motion Sensor/PIR Sensor:(purchase separately)
To install the motion/PIR sensor, first, open the driver cover by removing the
screws. Using the knockout on the side cover, mount the sensor, and make wire
connections in accordance with code . Once the wiring is complete, reattach
the driver cover.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>