Warehouse Lighting Plug and Play LED Tube Instruction Manual
- June 3, 2024
- Warehouse Lighting
Table of Contents
INSTALLATION INSTRUCTION
Plug and Play Led Tube
Prepare for Installation
- Check the ballast installed in the field and make sure the ballast is in the manufacturer’s ballast list.
- Loose and damaged lamp holders and sockets need to be adjusted or replaced.
Direct Replacement Procedure
-
Turn off the power to the light fixture at the breaker pane! before installation.
-
Open the diffuser from the light fixture.
-
Remove the fluorescent tubes. Please dispose of these items properly as they contain mercury.
-
Put led tube into the lighting fixture. Ensure pins are firmly seated in lamp holders.
-
Put led tube into the lighting fixture. Ensure pins are firmly seated in lamp holders.
-
Put led tube into the lighting fixture. Ensure pins are firmly seated in lamp holders.
-
Install the LED tubes, close the diffuser.
-
Switch on power to the fixture.
Dimming operation circle without ballast
Step 1: Turn on the on/off switch, if the user wants to use the maximum
brightness, no need any operation will be applied.
Step 2: If user wants a certain brightness, the user needs to turn on the
on/off switch again and the maximum brightness of 100% of the tube will be
reached at the beginning of this time, then the brightness will go down to 10%
of the maximum brightness within 5 seconds, it will reach a certain lumen as
user’s demand in the 5 seconds by pushing the on/off switch again, if not
pushing the on/off switch in 5 seconds, the brightness of the tube will go
from 10% to 100%, the user also can make the decision of the brightness within
this 5 seconds.
Step 3: If the user makes the decision by pushing the on/off switch to
off in the 5 seconds as above and turns the on/off switch in the next 20
seconds, the demanded brightness will be applied from that time.
Step 4: If the user didn’t follow step 3 pushing the on/off switch, the
100% of brightness will be applied, if the user wants to make demand
brightness again, the new operation circle needs to be conducted.
If with ordinary ballast, the lamp is at 100% brightness.
WARNING
- Risk of fire and electronic shock.
- This lamp can work with existing instant-start, rapid start, programmed start, dimming start, and emergency ballast as manufacturer ballast list.
- These lamps are to be used in indoor damp locations only.
- If the lamp or luminaire exhibits undesirable operation (Buzzing, Flickering, etc), immediately turn off the power, remove the lamp from the luminaire, and contact the manufacturer.
- Loose or damaged sockets or lamp holders need to be adjusted or replaced before installation.
- Do not make mass installation before sample testing.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>