Jetmax FY-RC-RF-RGB Mini LED RGB Remote Controller Instruction Manual
- June 6, 2024
- Jetmax
Table of Contents
**Jetmax FY-RC-RF-RGB Mini LED RGB Remote Controller Instruction Manual
**
SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
- Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use.
- This seasonal use product is not intended for permanent installation or use.
- Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
- Unplug the product when leaving the house, when retiring for the night, or if left unattended.
- Do not use this product for other than its intended use.
- Never operate this product if the power cord or plug is damaged.
- CAUTION: This is an electrical product – not a toy! To avoid risk of fire, burns, personal injury and electric shock, it should not be played with or placed where small children can reach it.
OPERATIONG INSTRUCTIONS
Controller on Remote assembly works in the same manner as the controller that
came with the tree. Pressing the button on the switch or remote control
operate the functions of the lights.
Pressing the TIMER button once will turn on the lights and begin the timer.
The timer will run continually: 6 hours with lights on, then 18 hours with
lights off and repeat until deactivated by pressing TIMER button.
BATTERY INSTALLATION
Remote Control requires one CR2025 button battery (battery included). Open battery compartment and insert one CR2025 button battery observing proper polarity(+/-).
Battery use reminders
- Always purchase the correct size and grade of battery most suitable for the intended use.
- Replace all batteries of a set at the same time.
- Clean the battery contacts and also those of the device prior to battery installation.
- Ensure the batteries are installed correctly with regard to polarity(+and -)
- Remove batteries from equipment which is not to be used for an extended period of time.
- Remove used batteries promptly.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. Note:
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequence energy and, if not installed and use din accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. if this equipmemt does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>