KRAMER 4K UDR SDVoE Video Streaming Transceiver Copper User Guide

June 7, 2024
Kramer

KRAMER logo

KRAMER 4K UDR SDVoE Video Streaming Transceiver Copper User Guide

KRAMER 4K UDR SDVoE Video Streaming Transceiver Copper

KDS-8 Quick Start Guide
This guide helps you install and use your KDS-8 for the first time.
Go to www.kramerav.com/downloads/KDS-8 to download the latest user manual and check if firmware upgrades are available.

Scan for full manual

Scan for full manual

Step 1: Check what’s in the box

  • KDS-8 4K SDVoETM Transceiver
  • 12V DC power adapter
  • 4 rubber feet
  • Quick start guide

Step 2: Get to know your KDS-8

FIG 1 Get to know your KDS-8

FIG 2 Get to know your KDS-8

FIG 3 Get to know your KDS-8

FIG 4 Get to know your KDS-8

FIG 5 Get to know your KDS-8

The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Step 3: Install the KDS-8
Mount to a flat surface using the attached mounting brackets or place on a flat surface.

Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your KDS-8. For best results, we recommend that you always use Kramer high-performance cables to connect AV equipment to the KDS-8.

FIG 6 Connect the inputs and outputs

Step 5: Connect the power
Connect to a 10G Ethernet switch that provides PoE (Power over Ethernet) or connect the power cord to KDS-8 and plug it into the mains electricity.

Safety Instructions

Caution: There are no operator serviceable parts inside the unit.
Warning: Use only the power cord that is supplied with the unit.
Warning: Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
Warning: Disconnect the power and unplug the unit from the wall before installing.

See www.KramerAV.com for updated safety information

Step 6: Operate the KDS-8
Change the encoder / decoder mode:
The unit is defined as an encoder by default.

  • Press and hold the + (plus) and – (minus) buttons simultaneously for 10 seconds. The encoder / decoder mode changes.

Stream Video:

  1. Connect a unit in encoder mode and a unit in decoder mode to the same 10G Ethernet switch. KDS-8 is plug-and-play with DHCP enabled.
  2. Subscribe the decoder to the encoder source using Kramer Network Enterprise Management Platform (go to www.kramerav.com/product/Kramer Network for more information).

www.kramerav.com

Read More About This Manual & Download PDF:

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals