dg casa BARDY Panel Bed Instruction Manual
- June 7, 2024
- dg casa
Table of Contents
BARDY PANEL BED
ASSEMBLY INSTRUCTION
12850-Q
WARNING
Seller and Manufacturer disclaim all and any liability for property damage,
personal injury, or loss, direct, indirect, or incidental, resulting from the
incorrect assembly, inadequate maintenance, improper use, or neglect of this
product.
NOTICE
- Keep these assembly instructions for future reference.
- Do not use this product if there are missing parts, damaged, or broken until repairs are made and/or factory replacement parts are installed.
- Check all packing material carefully for small hardware that may have become loose inside the carton during shipment.
- Identify and count all hardware and parts to compare with the parts and hardware list.
- Follow assembly instructions closely. Improper assembly can result in personal or property damage.
- Secure all bolts and screws before use.
- Every 90 days check all bolts and screws are secured.
- Some parts may have sharp corners or edges and may be heavy.
- Do not use or store this product near open flames or around flammable chemicals.
- When placing contents on non-carpeted flooring, it’s recommended to use floor protection such as an area rug or furniture pads. These are not included with the purchase.
REPLACEMENT PART OR HARDWARE REQUEST:
- Request a replacement by logging into the marketplace account in which the purchase was made and sending a message to the seller. To assist in expediting the request attach applicable images relevant to the request and/or part number and quantity.
**TOOLS REQUIRED:
HARDWARE
**
BARDY PANEL BED PARTS
ASSEMBLY INSTRUCTION
STEP 1
COMPONENTS AND HARDWARE TO BUILD THE BED ARE LOCATED IN THE HEADBOARD. UNZIP
THE ZIPPER COMPARTMENT LOCATED AT THE BACK OF THE HEADBOARD TO ACCESS THESE
PARTS.
STEP 2
ATTACH LEGS TO FOOTBOARD AND HEADBOARD AS SHOWN.
MATCH THE LABEL TO ENSURE THE
HEADBOARD LEGS ARE INSTALLED ONTO THE CORRECT SIDE OF THE HEADBOARD
STEP 3
ATTACH PART J TO THE HEADBOARD AND FOOTBOARD BRACKETS AS SHOWN.
STEP 4
ATTACH THE SIDE WING (11) TO THE HEADBOARD (A).
TO INSTALL THE SIDE WINGS, UNZIP THE BLACK NON-WOVEN FABRIC AND REZIP ONCE THE SIDE WINGS ARE INSTALLED.
STEP 5
ATTACH THE SIDE RAIL SUPPORT WOOD (G) TO THE SIDE RAIL (C).
STEP 6
ATTACH THE SIDE RAIL LEG (F) TO THE SIDE RAIL (C).
STEP 7
ATTACH SIDE RAIL (C) TO HEADBOARD (A) AND FOOTBOARD (B) BY PUSHING THE BRACKET
DOWN TO FIT IT.
STEP 8
ATTACH THE SUPPORT LEGS (I) TO THE SLATS (H).
ROTATE PART S CLOCKWISE OR COUNTERCLOCKWISE TO ADJUST SLAT HEIGHT FOR PROPER BOX SPRING SUPPORT
STEP 9
DO NOT PLACE THE
MATTRESS DIRECTLY ON TOP OF THE SLATS. A BOX SPRING IS REQUIRED AND A LOW
PROFILE BOX SPRING IS PREFERRED..
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>