HotWhHEELS Slot Car Track Set Instruction Manual
- June 7, 2024
- HotWhHEELS
Table of Contents
HotWhHEELS Slot Car Track Set Instruction Manual
CONTENTS
TOTAL: 85 PIECES
LAYOUT
ASSEMBLY
Adjust the distorted joints before joining tracks. Do not join the tracks together if the joints are distorted.
Hold and join tracks together as shown.
Attach the guardrail to the side of the track as shown.
Assemble the track support
TO PLAY
Control box – Battery installation (For B/O Version)
1. Unscrew the screw on the battery cover.
2. Open the battery cover.
3. Insert new 6 x AA (1.5V) batteries into the battery compartment of the
control box with the correct polarity (+/–).
4. Close the battery cover.
5. Tighten the screw on the battery cover.
Transmitter – Battery installation
- Unscrew the screw on the battery cover.
- Open the battery cover.
- Insert new 2 x AAA (1.5V) batteries into the battery compartment of each transmitter with the correct polarity (+/–).
- Close the battery cover.
- Tighten the screw on the battery cover.
MAINTENANCE
Guide pin must be in the slot as shown. Check the brushes of the car are in the correct position. Place the car on the track and make sure it has good contacts with the track.
The packaging and instruction manual contain important information. Please keep them for future reference. We reserve the right to improve/amend specifications and colors without notice.
SAFETY
- Alkaline batteries are recommended to be used (For B/O Version)
- Only batteries of the same or equivalent type as recommended are to be used
- Do not mix alkaline, standard or rechargeable batteries
- Do not mix old and new batteries or different type of batteries
- Non-rechargeable batteries are not to be charged
- Rechargeable batteries for adult charging only
- Rechargeable batteries are to be removed from the product before they are charged
- Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions
- Remove all batteries when not in use
- Exhausted batteries are to be removed from the product
- The supply terminals are not to be short-circuited
- Dispose of batteries properly. Do not dispose the batteries in fire it may cause them to explode or leak causing injury or damage
- Battery installation and removal must only be done by adult
FCC label compliance statement:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna
– Increase the separation between the equipment and receiver
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
– Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RSS-210 Compliance Statement:
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device ion.
Declaration of Conformity
The product is in conformity with the requirement of EU Directive 2014/53/EU
The instructions for battery toys with replaceable batteries shall contain the
substance of the following, as applicable:
Control box : AA batteries x 6 should be used. Transmitter : AAA
batteries x 4 (2 for each Transmitter) should be used.
Frequency band : 245008 -22446705MMHHzz Maximum radio frequency power transmitted : <0 dBm
Environmental notes:
The whole product also does not belong to household waste at the end of the
product life. You can return it at collection points for the recycling of
electronic and electronical instruments The symbol on the item, instruction
manual, hangtag or packing is showing this clearly. Materials should be
recycled according to their respective markings. Recycling of old devices or
other re-use of materials contained therein represents an important
contribution to environmental protection. Please ask at your local community
for the correct collection point.
Disposal of batteries
Batteries should not be disposed of in the household waste. As the consumer
you are legally obliged to return batteries containing harmful substances and
all other used batteries. You can hand in your old batteries at public
collection points in your area or wherever batteries are sold. You will find
these chemical abbreviations along with a crossed-out refuse bin on batteries
containing harmful substances: Pb=Battery contains lead Cd=Battery contains
cadmium Hg=Battery contains mercury
PRODUCT MUST BE ASSEMBLED BY ADULT ONLY.
Kidztech Toys Manufacturing Ltd., Hong Kong.
MADE IN CHINA.
HOT WHEELS and associated trademarks and trade dress are owned by, and used
under license from Mattel. ©2019 Mattel. All Rights Reserved.
CONSUMER INFORMATION
KIDZTECH TOYS MANUFACTURING LTD.
Room 802, 8/F, Inter-Continental Plaza,
94 Granville Road, TST East, Hong Kong.
Tel: (852) 27218868
info@kidztech.net
http://www.kidztech.net
PRODUCT: SLOT CAR TRACK SET
AGE GRADE: For ages over 5 years.
CONTENTS: All contents listed here.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>