HeathZenith Solar Powered Light User Guide
- June 7, 2024
- HeathZenith
Table of Contents
- HeathZenith Solar Powered Light User Guide
- FEATURES
- INITIAL BATTERY CHARGE
- UNPACKING
- WHERE TO MOUNT YOUR SOLAR POWERED LIGHT
- INSTALLATION
- OPERATION
- GENERAL ELECTRICAL AND SAFETY WARNINGS
- THINGS TO REMEMBER
- STORAGE
- TROUBLESHOOTING GUIDE
- TECHNICAL SERVICE
- TWO YEAR LIMITED WARRANTY
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
HeathZenith Solar Powered Light User Guide
FEATURES
- LED solar powered light.
- Switch activated light.
- No wiring required.
INITIAL BATTERY CHARGE
The solar panel requires full, direct sunlight to charge the battery. Clouds, rain, snow, and other weather conditions may not allow the solar panel to completely recharge the battery. Other obstructions such as buildings or trees may block the sun as well.
When installing the solar panel, make sure it is aimed as described below with a minimum amount of obstructions. If possible, mount the panel facing toward the southern sky.
- PRIOR TO USE, the battery will require 3 to 7 days of full sun to completely charge with the power selection switch in the OFF position. Plug the solar panel cable into the solar panel port on the bottom of the light fixture. If possible, aim the solar panel toward the south and tilt it approximately 50° from horizontal (see illustration on next page). If the solar panel cannot be aimed toward the south, then tilt the panel approximately 30° if possible.
- Actual operating time will vary depending upon how frequently the light is turned on and amount of sunlight collected.
- Solar lighting is not designed to equal standard 120V lighting. The amount of light output is reduced to allow the sun time to fully recharge the battery between lighting cycles.
UNPACKING
Be sure to remove all contents from packaging and verify all items are present before assembling this light fixture. This package includes the following items:
WHERE TO MOUNT YOUR SOLAR POWERED LIGHT
The most important thing to remember for the operation of your solar powered light is that it works from the power received from direct sunlight. The more direct sunlight the solar panel receives in a day, the longer the light will operate.
Solar Panel:
The solar panel converts the sun’s energy into electricity, thus charging the
battery stored in the solar light fixture. The solar panel requires direct
sunlight falling onto the face of the solar panel for as long as possible over
the course of the day.
When choosing the location for the solar panel, make sure it is aimed toward the south and is tilted to a suitable angle to allow as much direct sunlight to fall upon it as possible. Make sure there is a minimum amount of obstructions between the solar panel and the sun.
Also, make sure your solar panel location is not too far away from the solar light fixture for the wires to reach and connect.
INSTALLATION
Mounting the Solar Light Fixture (Screws):
- Mark the screw holes on a solid surface according to the illustration below. Install the screws (provided). Note: Ensure the fixture and the solar panel are located close enough together for the cord to reach.
- Place the keyholes on the rear of fixture on the screws.
Mounting the Solar Panel:
- Use the screws (provided) to mount the solar panel to a solid surface. IMPORTANT: Caulk around the base and on top of the screw heads after installation.
- Adjust the angle of the solar panel by moving the adjustment support to the appropriate hook on the mounting bracket. Remember, the solar panel must receive as much direct sunlight over the course of the day as possible. Keep in mind that shadows may block the sunlight from reaching the solar panel during the day.
- Carefully route the solar panel cable to the light fixture. Plug the solar panel cable into the connector extending from the side of the battery case.
IMPORTANT: Turn the power selection switch to the OFF position and allow the battery to charge with 3 to 7 days of full sunshine before testing.
OPERATION
- Allow 3 to 7 days of charging under full sunshine before using the light for the first time.
- Use the switch located on the bottom of the LED light to turn the light ON/OFF. IMPORTANT: The solar panel will not be able to keep the battery charged if the light is left in the ON position. Leaving the light on for a prolonged period of time could damage the battery.
GENERAL ELECTRICAL AND SAFETY WARNINGS
- Do not cut the solar panel wire. Discontinue use if the wire becomes frayed or broken.
- Do not immerse components in liquid.
- Do not use any other charging device other than the single solar charging panel provided with this light. Doing so may result in injury or damage to the light and voids any warranty.
- Position the cord so that it is securely fastened and will not result in a hazard (such as tripping).
THINGS TO REMEMBER
- Periodically clean the solar panel with a soft cloth and warm water. Do not hose spray. Keep the collector clear of snow and leaves. Make sure trees and other objects do not block sunlight from the panel.
- Solar collection is only effective in direct sunlight. Every hour the light is on requires a minimum of 16 hours of sunlight charging. Solar panels collect less than 10% of the sun’s energy.
- Several days of use with overcast skies may discharge the battery. If so, turn the power selection switch to the OFF position and allow the sun to charge the battery for 3 to 7 days.
STORAGE
If you wish to store your light indoors for more than two or three days, follow these steps to prevent damage to the battery:
- Turn the power selection switch to the OFF position.
- Keep the solar panel cord connected to the light and store the light and solar panel where the solar panel can receive some sunlight or room light each day. The battery needs light to maintain a charge during storage.
TROUBLESHOOTING GUIDE
HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
TECHNICAL SERVICE
Please call 1-800-858-8501 for
assistance before returning product to store.
If you experience a problem, follow this guide. You may also want to visit our
Web site at: www.hzsupport.com. If the problem
persists, call for assistance at
1-800-858-8501, 8:00 AM to 5:00 PM CST
(M-F). You may also write to:
HeathCo LLC
P.O. Box 90045
Bowling Green, KY 42102-9045
ATTN: Technical Service
- If contacting Technical Service, please have the following information available: Model Number, Date of Purchase, and Place of Purchase.
No Service Parts Available for this Product
Please keep your dated sales receipt, it is required for all warranty
requests.
HeathCo LLC reserves the right to discontinue products and to change
specifications at any time without incurring any obligation to incorporate new
features in products previously sold.
TWO YEAR LIMITED WARRANTY
This is a “Limited Warranty” which gives you specific legal rights. You may also have other rights which vary from state to state or province to province.
For a period of two years from the date of purchase, any malfunction caused by factory defective parts or workmanship will be corrected at no charge to you.
Not Covered – Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries, and other expendable items are not covered by this warranty. Unauthorized service or modification of the product or of any furnished component will void this warranty in its entirety. This warranty does not include reimbursement for inconvenience, installation, setup time, loss of use, unauthorized service, or return shipping charges.
This warranty covers only HeathCo LLC assembled products and is not extended to other equipment and components that a customer uses in conjunction with our products.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY, REPRESENTATION OR CONDITION OF MERCHANT ABILITY OR THAT THE PRODUCTS ARE FIT FOR ANY PARTICULAR PURPOSE OR USE, AND SPECIFICALLY IN LIEU OF ALL SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES.
REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL
BE NO LIABILITY ON THE PART OF HEATHCO LLC FOR ANY SPECIAL, INDIRECT,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING
BUT NOT LIMITED TO ANY LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT
FORESEEABLE. Some states or provinces do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation or exclusion
may not apply to you. Please keep your dated sales receipt, it is required for
all warranty requests.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>