FANATEC ClubSport Porsche 918 RSR User Guide
- June 7, 2024
- FANATEC
Table of Contents
FANATEC ClubSport Porsche 918 RSR User Guide
ATTACHING THE STEERING WHEEL
Warning: Make sure the newest CSW Base firmware file has been downloaded. You can obtain it at Fanatec’s website (www.fanatec.com) in the download section.
-
Remove storage pin
-
Align ClubSport Wheel Base axle, to correct position.
-
Press togther or “pinch” and hold Quick Release mechanism.
-
Slide Rim onto ClubSport Wheel Base axle.
-
Now release the sleeve of the Quick Release mechanism.
DETACHING THE STEERNIG WHEEL
-
Pinch and hold
Quick Release mechanism
-
Slide Rim off ClubSport Wheel Base axle
-
Place Rim face down on table
-
Insert storage pin
-
Now release the sleeve of the Quick Release mechanism
MODE
In order to switch between modes, simultaneously press and hold the two buttons highlighted below for one second. The wheel base LED indicates the active mode:
- Red indicates PC mode
- Blue indicates PS4™ mode*
- Purple indicates compatibility mode*
* Not applicable for every Fanatec wheel base. Please check the individual user manual of your Fanatec wheel base.
BUTTON MAPPING
CENTRE CALIBRATION
If a centre calibration is needed (e.g: after firmware update of ClubSport Wheel Base) when using the steering wheel you need to enter the Tuning Menu by pressing the Tuning Button.
When the Tuning Menu is active, press the analogue stick and the FunkySwitch™ at the same time as illustrated on the right in order to calibrate the wheel centre.
TUNING OPTIONS
In order to enter Tuning Menu, press the Tuning button. In order to navigate inside the menu, use the right FunkySwitch™. Press it up or down to access 5 setups. Press the FunkySwitch™, right or left, to go through the options and turn the FunkySwitch™ to change option values.
SHIFTER CALIBRATION
In order to enter shifter calibration mode, simultaneously press the Tuning Button and the button highlighted below.
SHIFTER PADDLE OPTIONS
Detail A
Manufactured by
Fanatec® is a registered trademark of Endor AG
Designed and developed by Endor AG in Germany
E.ON-Allee 3 – 84036 Landshut – Germany
Telephone: +49 (871) 9221-122
Fax: +49 (871) 9221-221
Email: info.webshop@fanatec.com
Website: www.fanatec.com –
www.endor.ag
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>