VYTRONIX BAGGED Vacuum Cleaner User Guide
- June 7, 2024
- VYTRONIX
Table of Contents
BAGGED VACUUM CLEANER
USER GUIDE
BGGC01
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS
BEFORE USING (THIS APPLIANCE)
WARNING- To reduces the risk of fire, electric shock, or injury:
- Do not leave a vacuum cleaner when plugged in. Unplug from outlet when no use and before servicing.
- To reduce the risk of electric shock, do not use outdoors or on wet surfaces
- Use only as described in this manual. Use only manufacturers’ recommended attachments.
- Do not use with damaged cord or plug. If the vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, enter it to a service center.
- Do not pull or carry on the cord, use cord as a handle, close door on cord, or pull cord around sharp edges or corners. Do not run the vacuum cleaner over the cord. Keep cord away from heated surfaces.
- Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord.
- Do not handle plug or vacuum cleaner with wet hands.
- Do not put any object into openings. Do not use with any opening blocked. Keep free of dust, lint, hair, and anything that may reduce airflow.
- Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts.
- Turn all controls off before unplugging.
- Use extra care when cleaning on stairs.
- Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present
- Hold the plug when rewinding onto the cord reel. Do not allow the plug to whip when rewinding.
- .Unplug before connecting the hose
- Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
- Do not use without a dust bag and/or filter in place.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instructions concerning the use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instructions concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
- Cleaning and user maintenance shall not be done by children without supervision
SAVE THESE INSTRUCTIONS!
COMPONENTS AND EQUIPMENT
- Floor nozzle
- Extension tube
- Accessories holder
- Air slide
- Suction hose
- Cord rewind button
- ON/OFF button
- Carrying handle
- Suction hose connection10. Crevice Nozzle
- Upholstery nozzle
PREVENTION
Switch off the vacuum cleaner immediately if the air intakes, the floor brushes or the telescope’s tube become blocked. Before starting the vacuum cleaner up again remove the substance causing the blockage:
-
Never use the vacuum cleaner in the immediate vicinity of firs or radiators or any other appliance emitting heat. Do not suck up hot objects such as cigarette ends or ashes..
-
Only place the plug in the socket when your hands are dry.
-
Please remove large of sharp objects from the floor before using the vacuum cleaner to avoid any possible damage to it.
-
Do not pull by the mains cable when pulling out the plug.
PREPARING THE VACUUM CLEANER
-
Fit the hose on the vacuum cleaner by inserting the rotating hose connection into the vacuum cleaner until you hear a click. To remove the hose, press the button at the side of the hose connection and pull it out.
-
Assembling the telescopic extension tube and accessories
2.1: Fit the telescopic tube onto the other end of the hose.
2.2: Fit the floor brush onto the extension tube.
Floor Nozzle
the floor nozzle has two settings. When cleaning hard surfaces(parquet
flooring, flooring tiles, etc.), the nozzle brushes should be extended. When
cleaning carpets and mats, the brushes should be retracted into the nozzle.
Press the brush change button to switch between the two settings.
Crevice nozzle
For radiators, corners, skirting, etc.
Furniture nozzle
For furniture, curtains, drapes, etc.
USE Vacuum cleaning
-
Before using the device first roll out a sufficient length of mains cable and plug into the mains socket. The yellow mark on the electric flex cable is the maximum length that must not be exceeded.
To switch on the device, press the foot pedal button on the casing with your foot -
To rewind the power cable, press the button
Hold the cable with one hand and guide the cable to ensure that it does not whip causing damage.
Caution:
Never operate the vacuum cleaner without the dust bag or motor filter,
otherwise, the device could be damaged.
How to use MIF bag
If the suction power is reduced, this may indicate the necessity of changing
the dust bag. Raise the nozzle off the floor, set the suction power regulation
to MAX, switch on the vacuum cleaner using the on/off switch, and check the
dust bag full indicator. If it is red, the bag must be changed.
- Switch off and unplug the appliance.
- Remove the hose, open the bag cover by pushing latch-up, and lifting the bag cover.
- Carefully remove the disposable bag from the vacuum cleaner.
- Install a new bag in the vacuum cleaner.
- The bag compartment cover will not close if no bag is installed in the vacuum cleaner
How to use a reusable bag
If the suction power is reduced, this may indicate the necessary emptying the
dust bag. Raise the nozzle off the floor, set the suction power regulation to
MAX, switch on the vacuum cleaner using the on/off switch, and check the dust
bag full indicator. If it is red, the bag must be emptied.
- Switch off and unplug the appliance.
- Remove the hose, open bag cover by pushing the latch-up and lifting the bag cover.
- Carefully remove the reusable bag from the vacuum cleaner. Slide the clip of the reusable bag sideways.
- Shake out the contents into a dustbin.
- To reassemble the reusable bag, fold it in the form of an accordion (see illustration) and then insert it into the locking strip.
- Make sure, that the edges of the cloth folded in the form of an accordion were inserted into the locking strip evenly on both sides.
- Install properly closed the reusable bag in the vacuum cleaner.
- Close the vacuum cleaner again.
- The bag compartment cover will not close if no bag is installed in the vacuum cleaner.
- Always clean the reusable bag after vacuuming large quantities of fine material such as fine dust.
Please note- if the suction is still not adequate after emptying then the textile bag then bag can be washed in warm soapy water and rinsed with clean water, but you must allow the bag to dry for 24 hours before reusing the machine.
Remove/Install the dust bag
- Turn off and unplug the cleaner.
- Remove the hose, open bag cover by pushing the latch up with fingers, and lifting the bag cover.
- Grasp the millboard at the top of the dust bag and carefully remove the bag from the vacuum clean4. Empty the rubbish.
- Insert the dust bag in the vacuum cleaner.
- Close the vacuum cleaner again
Cleaning the motor filter
-
The motor filter can be found in the dust bag container.
It protects the motor from dust and should be cleaned at least twice a year, when it is dirty, or if suction force is reduced. 2. Pull the filter holder up out of the vacuum cleaner open the filter holder, and remove the filter. Rinse the filter in tepid water, and allow it to dry for 24hours. Do not use a hairdryer or similar to dry the filter
-
Return the filter to the holder, and replace the filter holder in the vacuum cleaner.
IMPORTANT! Never use the vacuum cleaner without a motor filter
IMPORTANT INFORMATION
This Vacuum Cleaner is fitted with an internal safety thermal cut-out.
The Vacuum Cleaner will switch off automatically when it overheats.
The Vacuum Cleaner will overheat if the filters are clogged, the hose is
blocked or the dust bag is full.
If the Vacuum Cleaner cuts out, empty the dust bag, remove any blockages and
clean the filter out before using it again.
The Vacuum Cleaner will be functional again in 30-60 minutes after cooling
down.
Transport and Storage
- You can lift and carry the vacuum cleaner using the carrying handle. Never pull or lift the vacuum cleaner by the cord.
- Before putting the vacuum away, rewind the cord. Switch off the socket, unplug, and press the cord rewind button until the cord is fully rewound.
- To save space, the vacuum can be stored upright on its end cover. The telescopic tube can be hung on the vacuum cleaner by inserting the parking fixture into the vertical parking holder.
Cleaning
Clean the vacuum cleaner by wiping it with a damp cloth.
You must not use any form of strong, solvent or abrasive cleaning agent.
Environmental tips
Once any electronic product is no longer functional, it should be disposed of in such a way as to cause minimum environmental impact, in accordance with the regulations of your local authority. In most cases, you can take such products to your local recycling station.
Don’t forget to register for your 12-month guarantee at www.vytronix.com using product code Brandnew-vytronix-bggc01
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>