My CrossWave X7 Leaves Streaks | Support
- June 7, 2024
- Bissell
Table of Contents
If you are experience streaking, follow these steps to resolve:
-
Make sure you are filling the Clean Water Tank with the correct amount of BISSELL formula
-
Too much water may have been left on floor
- Go over area without pressing trigger to suction up any residual water
- Ensure you are in correct cleaning mode, hard floor mode will dispense less solution than area rug & TURBO PET mode
-
Remove and clean filter and filter screen under warm water
- Allow to fully dry before reassembling
-
Clean and dry your brush roll window, brush roll, brush ends, brush gear, and brush housing > Go to Brush Not Turning
- When brush roll is removed, clear any debris from the suction path behind the brush roll
-
Re-insert a new brush roll and attempt a few cleaning strokes with the trigger pulled and released
-
It is not recommended to use CrossWave on any waxed or unsealed floors
-
Has this resolved the issue?
- Yes > Great! Glad I could get you back to cleaning!
- No > Order a new Brush Roll & Filter > Go to Parts & Supplies
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>