My PowerClean®/MultiClean® Wet and Dry Vacuum has no suction | Support

• Both filters (Fabric and Mesh) should be in place on machine while in use for Wet & Dry cleaning

  • Remove hose

  • Turn machine on, check for suction at the opening on the front of the machine

  • Remove lid if no suction at opening by releasing latches on side of machine

  • Remove Fabric filter and clear of any debris

    • Filter can be hand washed using cold water & mild dish soap
    • Rinse well
    • Allow to air dry completely before reinstalling (24 – 48 hours)

  • Empty tank

  • Clear debris from the suction inlet (both inside & out)

  • Remove the Filter Cage from the underside of the top cover

    • Turn counter clockwise to unlock

  • Remove the Mesh Filter

    • Mesh filter can be rinsed in cold water
    • Allow to completely air dry before reinstalling (24 – 48 hours)

  • Make sure the float is positioned at the bottom of basket behind filter

    • If not, tap basket – Float should move freely

  • Return Mesh filter to tank lid

  • Lock filter cage around mesh filter by twisting clockwise

  • Place Fabric filter into tank

    • If Fabric filter is missing the Tank lid will not be secure & will result in reduced suction.

  • Reattach Tank lid, secure latches on both sides

  • Turn on & check again for suction at opening on front of machine

    • If still no suction, please visit a BISSELL Authorized Service Center or Contact Us

If opening does have suction, inspect the hose, wand, and attachment for clogs

• Separate each piece

• Remove curved piece at end of hose (push tabs to release)

• Separate extension wands

• Push broomstick through hose & wands to clear any debris or clogs

• If hose, wand or any attachments are damaged they should be replaced

• Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>