Brush Maintenance | How to Video | CleanView® Connect Robotic Vacuum
- June 7, 2024
- Bissell
Table of Contents
Brush Maintenance
- Cleaning & Replacing the Brush Roll
- Make sure the robot is turned off
- Pinch tabs on the brush roll guard and pull brush roll out
- Wipe brush roll chamber clean
- Clean brush roll with the included cleaning tool
- Test to make sure the brush spins freely
- Put clean brush roll back in the robot
- Put brush guard back on. Make sure the square-shaped end piece of the guard matches the square-shaped port
Cleaning & Replacing the Edge Cleaning Brushes
- A Phillips-head screwdriver is required
- Make sure your robot is turned off
- Turn robot over so bottom is facing up
- Remove the screws on the edge cleaning brushes and pull the brushes off
- Screw new brushes onto robot
- If you need a replacement brush roll or edge cleaning brushes, order them here
-PFGInr1ZAE
- Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>