FENIX PD35R Rechargeable Flashlight User Manual
- June 11, 2024
- FENIX
Table of Contents
FENIX PD35R Rechargeable Flashlight User Manual
WARNING
- Do place this light out of the reach of children!
- Do NOT shine the light directly Into the eyes of anyone!
- Do NOT shine flammable objects at close range, to avoid burning objects or causing danger due to high temperature!
- Do NOT use the light in inappropriate ways such as biting in the mouth, to avoid personal injury or We threats when the light or internal battery fails!
- This light will accumulate a lot of heat while working, resulting in a high temperature of the flashlight shell. Pay attention to safe use to avoid scalding.
- Turn off and lock the fight or remove the battery from the light to prevent accidental activation when the light is placed in a dosed and flammable environment such as pockets and backpacks!
- The LED of this flashlight Is not replaceable; so the whole light should be replaced when the LED reaches the end of its life.
FENIX PD35R FLASHLIGHT
- 1700 lumens maximum output, 353 meters maximum beam distance.
- Uses a Luminus SFT40 LED with a lifespan of 50,000 hours.
- Included a 3400mAh battery and is compatible with 2 x CR123A batteries.
- Instant activation and instant strobe with dual tai switches. USB Type-C charging port with inner waterproofing treatment.
- Boot-up battery level indication and low-voltage warning.
- Included a premium pocket dip and lanyard for convenient use.
- Made of durable A6061-T6 aluminum.
- Premium type HAITI hard-anodized anti-abrasive finish.
- Size: 5.35″ x 1.00″ x 0.91″ / 136 x 25.4 x 23.2 mm.
- Weight: 4.9 oz / 140 g (including battery).
OPERATING INSTRUCTION
Switches
Main switch: for on/off and instant activation. Auxiliary switch: for output
selection and instant strobe.
On/off
Tap the main switch to silently and momentarily turn on the light, releasing
the light will go out Fully press the main switch to constantly turn on the
light, press again the light wit go out.
Output Selection
With the light switched on, single dick the auxiliary switch to cycle through
Tutho—•Eco—•Low—,Med—.High.
Strobe
With the light switched on. press and hold the auxiliary switch for 0.5
seconds to enter strobe, and dick the auxiliary switch once again to turn
Type| Dimension| Nominal voltage| Usability|
---|---|---|---|---
Fenix ARB L 18 series| 18650| 3.6V| Recommended|
Non-rechargeable Battery (LlthTum)| CR123A| 3\/| Usable (No charging)| 9
Rechar9eaue Battery(L’-‹c )| 18650| 3.6V| Cau;on”|
Rechargeable| 18650| 3.2V| Banned|
Unscrew the light tail and insert the battery with the anode side (+) towards the light head, then screw the light tail back on.
CHARGING
- First switch off the light and plug the USB A socket of the charging cable into an electrical outlet, then connect the USB Type-C socket of the charging cable to the light.
- The indicator will display red while charging, and will turn green when fully charged.
- Once charging is completed, be sure to close the anti-dust cover to maintain the dustproof and waterproof ability.
Note:
- The normal charging time of the included Fenix ARB-L18-3400 rechargeable battery is approximately 3 hours from depletion to full charging.
- Recharge a stored light every four months to maintain optimum performance of the battery.
- The light is unavailable while charging.
- Charge the flashlight when it is turned on, the light will turn off immediately. After removing the charging cable, it will automatically recall the memorized lighting mode. For avoiding the risk, please turn it off before charging.
BATTERY LEVEL INDICATION
Each time the light is turned on, the indicator will indicate the battery
level and will last for 3 seconds.
Green light on: saturated 100% – 85%
Green light flashes: sufficient 85% – 50%
Red light on: poor 50% – 25%
Red light flashes: critical 25% – 1%
INTELLIGENT OVERHEAT PROTECTION
The light will accumulate a lot of heat when used on High or Turbo modes for extended periods. When the light reaches a temperature of 60°C or above, the light will automatically step down a few lumens to reduce the temperature. When the temperature drops below 60°C, it will then allow the user the reselection of High or Turbo modes.
LOW-VOLTAGE WARNING
When the voltage level drops below the preset level, the flashlight is programmed to downshift to a lower brightness level until Eco output is reached. When this happens in Eco output mode, the light blinks 3 times every 5 minutes to remind you to timely recharge or replace the battery. Note: This only works with Fenix ARB-L18 series rechargeable battery.
USAGE AND MAINTENANCE
- Disassembling the sealed head can cause damage to the light and will void the warranty.
- Fenix recommends using only a high-quality protected battery.
- If the light will not be used for an extended period, remove the battery for proper storage.
- Unscrew the tail cap or remove the battery to prevent accidental activation during storage or transportation.
- Long-term use can result in 0-ring wear. To maintain a proper water seal, replace the ring with an approved spare.
- Periodic cleaning of the battery contacts improves the light’s performance as dirty contacts may cause the light to flicker, shine intermittently or even fail to illuminate for the following reasons:
A: Poor battery level. Solution: Recharge or replace the battery.
B: The contact or contact point of the battery or flashlight is dirty. Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol. If the above methods don’t work, please contact your authorized distributor.
INCLUDED
Fenix PD35R Flashlight, ARB-L18-3400 battery, USB Type-C charging cable, Holster, Lanyard, Spare 0-ring, User manual, Warranty card
FENIXLIGHT LIMITED
Tel: +86-755-29631163/83/93
Fax: +86-755-29631181
E-mail: info@fenixlight.com
Web: www.fenixlight.com
Address: 2F/3F, West of Building A, Xinghong Technology Park, 111 Shuiku
Road, Fenghuanggang Community, Xixiang Street, Bao’an District, Shenzhen City,
Guangdong Province, China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>