HENDI Donut fryer User Manual

Donut fryer
User manual

Item: 205914

You should read this user manual carefully before using the appliance.

Dear Customer,
Thank you for purchasing this Fiesta Queen appliance. Before using the appliance for the first time, please read this manual carefully, paying particular attention to the safety regulations outlined below.

Safety regulations

• This appliance is intended for commercial use only and must not be used for household use.

• The appliance must only be used for the purpose for which it was intended and designed. The manufacturer is not liable for any damage caused by incorrect operation and
  improper use.

• Keep the appliance and electrical plug away from water and any other liquids. In the event that the appliance should fall into water, immediately remove plug from the socket and do not use it until the appliance has been checked by a certified technician. Failure to follow these instructions could cause a risk to lives.

• Never attempt to open the casing of the appliance yourself.

• Do not insert any objects in the casing of the appliance.

• Do not touch the plug with wet or damp hands.

• The danger of electric shock! Do not attempt to repair the appliance yourself. In case of malfunctions, repairs are to be conducted by qualified personnel only.

• Never use a damaged appliance! Disconnect the appliance from the electrical outlet and contact the retailer if it is damaged.

• Warning! Do not immerse the electrical parts of the appliance in water or other liquids.
  Never hold the appliance under running water.

• Regularly check the power plug and cord for any damage. If the power plug or power cord is damaged, it must be replaced by a service agent or similarly qualified persons in order to avoid danger or injury.

• Make sure the cord does not come in contact with sharp or hot objects and keep it away from an open fire. To pull the plug out of the socket, always pull on the plug and not on the cord.

• Ensure that the cord (or extension cord) is positioned so that it will not cause a trip hazard.

• Always keep an eye on the appliance when in use.

• Warning! As long as the plug is in the socket the appliance is connected to the power source.

• Turn off the appliance before pulling the plug out of the socket.

• Never carry the appliance by the cord.

• Do not use any extra devices that are not supplied along with the appliance.

• Only connect the appliance to an electrical outlet with the voltage and frequency mentioned on the appliance label.

• Connect the power plug to an easily accessible electrical outlet so that in case of emergency the appliance can be unplugged immediately. To completely switch off the appliance pull the power plug out of the electrical outlet.

• Always turn the appliance off before disconnecting the plug.

• Never use accessories other than those recommended by the manufacturer. Failure to do so could pose a safety risk to the user and could damage the appliance. Only use original parts and accessories.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge.

• This appliance must not be used by children under any circumstances.

• Keep the appliance and its cord out of reach of children.

• Always disconnect the appliance from the mains if it is left unattended or is not in use, and before assembly, disassembly or cleaning.

•  Never leave the appliance unattended during use.

Special safety precautions

• This appliance is intended only for frying appropriate food such as donuts, fries, etc in commercial use. Any other use may lead to damage of the appliance or personal injury.

• This appliance is intended to be used for commercial applications, for example in kitchens of restaurants, canteens, hospitals, and in commercial enterprises such as bakeries,
  butcheries, etc., but not for continuous mass production of food. And it should be operated by trained personnel.

• Caution! Hot surface! The temperature of the accessible surface is very hot during use. Touch the switch and the temperature control knob only.

• When this appliance is to be positioned in close proximity to a wall, partitions, kitchen furniture, decorative finishes, etc., it is recommended that they are made of non-combustible material; if not, they shall be cladded with a suitable non-combustible heat insulating material, and that the closest attention be paid to fire prevention regulations.

• Do not place the appliance on a heating object (gasoline, electric, charcoal cooker, etc.).  Keep the appliance away from any hot surfaces and open flames. Always operate the appliance on a level, stable, clean, heat-resistant, and dry surface.

• Do not use the appliance near explosive or flammable materials, credit cards, magnetic discs or radios.

• This appliance is not intended to be operated by means of an external timer or separate remote-control system.

• WARNING: Always make sure the oil level between MAX & MIN marking in the oil container. The danger of fire if oil level below MIN marking.

• WARNING: Do not fry too wet foodstuffs and too much food at each time to avoid excessively foaming and spill out of oil. The maximum batch load is approximately 1kg.

• Allow at least 20 cm spacing around the appliance for ventilation purposes during use after installing the frying grid holder.

• Only use suitable oil or fat for frying. Replace the oil or fat at regular intervals. Overcooked or dirty oil or fat can be ignited if it is overheated.

• Do not use plastic cutlery during operation.

• Danger! Never use old oil, old oil has a reduced flash point and is more prone to surge boiling which increases the risk of fire and dangerous situations.

• Always clean the appliance and other accessories after each use (–>Cleaning and maintenance).

• Do not use a water jet, flush directly with water or steam cleaner as the parts will get wet and electric shock might result.

• Caution! Securely route the power cord if necessary in order to prevent unintentional pulling or contact with the heating surface.

• Do not wash the appliance with water. Washing can cause leakages and increase the risk of electric shock.

• Do not clean or store the appliance unless it is completely cooled down.

• Always remove the plug from the socket when filling or cleaning the appliance.

• The electrical installation must satisfy the applicable national and local regulations.

• The oil container with a heating element should be placed in a safe position in your kitchen before usage due to the hot contents when in use.

• No part is dishwasher safe.

Intended use

• The appliance is intended for professional use and can be operated only by qualified personnel.
• This appliance is intended only for frying appropriate food such as donuts, fries, etc in commercial use. Any other use may lead to damage of the appliance or personal injury.
• Operating the appliance for any other purpose shall be deemed a misuse of the device. The user shall be solely liable for improper use of the device.

Grounding installation
This appliance is classified as a protection class I appliance and must be connected to protective ground. Grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded.

Preparations before using for the first time

• Check to make sure the appliance is undamaged. In case of incomplete delivery (2 frying grids & 1 bottom grid included) or any damages, contact your supplier immediately and DO NOT use the appliance.
• Remove all the packing material and protection film (if applicable).
• Clean the appliance with lukewarm water and a soft cloth.
• Place the appliance on a level and steady surface, unless mentioned otherwise.
• Make sure there is enough clearance around the appliance for ventilation purposes. Especially, allow enough spacing for placing the frying grid holder (8).
• Position the appliance in such a way that the plug is accessible at all times.

Installation

• Place the appliance on a level, stable, clean, heat-resistant, and dry surface with its rubber feet.
• Carefully install the back support with a heating element (4) on the rear edge of the oil container.
• Place the bottom grid (9) at the bottom of the oil container (5).
• Set up the frying grid holder (8) on either the right or left side of the oil container (5).

Note:

1.  Make sure that the rear support is in the correct position & properly inserted into 2 slots at 2 sides of the oil container (5).
2. The appliance should be placed in a safe position in your kitchen before use due to heat hazards when in use.

Main parts of the appliance

1. Main switch (Green) [ON (I) / OFF (0)] 2. Temperature indicator (Orange)
3. Temperature control
4. Detachable rear support with the heating element
5. Oil container (400x400x(H)160 mm)| 6. Oil drain tap
7. Frying grid (2x 354x383x(H)102 mm)
8. Frying grid holder (1x 423x446x(H)40 mm)
9. Bottom grid (1x 390x365x(H)40 mm)
---|---

Use

• Make sure the oil drain tap is closed.
• Remove the plug from the socket.
• Make sure the oil container is clean and dry and no water inside.
• Carefully fill the oil container with oil between the “MIN” and the “MAX” marking.
• Plug the earthed plug into an earthed socket.
• You can now use the appliance.

Operation

• Fill the container (5) with oil and make sure the oil level is between the MIN and MAX marking. Note: Remember that placing food in the oil will also raise the oil level. Do not put too wet foodstuffs or large amounts of food at each time.

• Connect the power plug to a suitable electrical power outlet.

• witch ON the appliance by pressing the main switch (1) to the “I” position. The switch will light up in green. Rotate the temperature control (3) clockwise to the desired Set
  Temperature. The orange indicator (2) will light up. [Temperature range: 50°C ~ MAX (190°C)].

• When the set temperature is reached, the orange indicator (2) will go out. Now, you can use the appliance. Note: The frying grid holder (8) is just for temporarily holding of trying grid for excess oil discharge only. Do not hold too long time or place other objects on it to prevent it from falling down accidentally.

RESET the Hi-limiter (thermal cut-out)
Please note that the RESET button is located at the back of the detachable rear support (4) with a protective cap (see picture) to avoid overheat.

• Unplug the appliance from the electrical outlet first.
• Allow the appliance to completely cool down.
• Unscrew the black protective cap of the RESET button.
• Press the RESET button of the  Hi-limiter(thermal cut-out). You should hear a click sound.
• Screw back the protective cap on the RESET button.

Frying tips

• Only use liquid frying oil (preferably) or fat.
• The recommended temperature for frying chips and snacks is 175°C.
• Heat the oil slowly. Preferably in 3 steps for example first at 100°C, then from 100-140°Cand later from 140°C to 175°C with 15minutes breaks between steps.
• Remove ice and crumbs from frozen foods.
• Do not fry too much at one time. This can cause the oil or fat to cool down too much. Cooled-down oil/fat does not properly sear the surface of the food so that more fat will be absorbed. The ideal proportion of frozen products to frying oil/fat is 1:10 maximum.
• When used intensively, crumbs and other debris should be filtered out of the oil/fat.
• Replace oil or fat in time. Use test strips or test equipment regularly to track when oil/fat should be replaced.
• If oil or fat starts to foam, smoke or gets too viscous you should replace it. Also, replace the oil/fat when it has a strong smell or taste.

After use

• Switch OFF the appliance by pressing the main switch (1) to the “0” position and unplug the appliance.
• Remove the frying grid (7) from the oil container(5). This avoids the frying grid (7) becoming stuck in the solidified fat.
• Overturn the frying grid holder (8) & place it on the top of oil container (5) with 4 raised stoppers (see picture) in the right position.

Cleaning and maintenance

• Always remove the plug from the socket and let it cool down completely before cleaning the appliance.

• Beware: Never immerse the appliance in water or any other liquid!

• Clean the outside of the appliance with a damp cloth (water with mild detergent).

• Never use aggressive cleaning agents or abrasives. Do not use any sharp or pointed objects.
  Do not use petrol or solvents! Clean with a damp cloth and detergent if necessary. Do not use abrasive materials.

• Do not clean the appliance with a steam cleaner or water jet.

• Assemble the appliance after cleaning and make sure that the heating & control panel is mounted properly, otherwise, the appliance will not function.

Technical specification
Protection class: Class I
Waterproof protection class: IPX3

Item| Dimension after placing the frying  grid holder [mml| Capacity [II| Rated wattage [WI| Temperature rangeNC)| Operating voltage [v]| Total net weight [kg)
---|---|---|---|---|---|---
205914| 630x860x(H)360| 12| 3500| 50 – 190| 230| 16,3

Troubleshooting

If the appliance does not function properly, please check the below table for the solution. If you are still unable to solve the problem, please contact the supplier/service provider.

The appliance does not switch ON. The main switch (1) does not light up in green.| Power plug is not connected properly with the electrical power outlet.| Make sure the power plug is connected properly with the electrical power outlet.
The main switch (1) is not pressed.  position.| Press the main switch (1) to the –I–
The rear support with heating ele­ment (4) is not properly mounted.| Properly placed the rear support with a heating element (4) on the oil contain­er (5).
Inside microswitch is defective.| Contact your supplier.
The appliance does not heat up and temperature indicator (2) does not light up. But main switch (1) lights up in green.| Hi-limiter (thermal cut-out) activates.| Reset the Hi-limiter (thermal cut-out) (See ==> RESET the thermal cut-out).
Hi-limiter (thermal cut-out) defective.| Contact your supplier.
Temperature control. (3) defective.| Contact your supplier.
Appliance does not reach the set temperature after a long frying time.| Heating element defective| Contact your supplier.
Temperature control. (3) defective.| Contact your supplier.

In case of any doubt, always contact your supplier!

Warranty

Any defect affecting the functionality of the appliance which becomes apparent within one year after purchase w

When decommissioning the appliance, the product must not be disposed of with another household waste. Instead, it is your will be repaired by free repair or replacement provided the appliance has been used and maintained in accordance with the instructions and has not been abused or misused in any way. Your statutory rights are not affected. If the appliance is claimed under warranty, state where and when it was purchased, and include proof of purchase (e.g. receipt).
In line with our policy of continuous product development, we reserve the right to change the product, packaging, and documentation specifications without notice.

Discarding & Environmentsponsibility to dispose to your waste equipment by handing it over to a designated collection point. Failure to follow this rule may be penalized in accordance with applicable regulations on waste disposal. The separate collection and recycling of your waste equipment at the time of disposal will help conserve natural- sources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste for recycling, please contact your local waste collection company. The manufacturers and
importers do not take responsibility for recycling, treatment, and ecological disposal, either directly or through a public system.

Hendi B.V.
Steenoven 21
3911 TX Rhenen, The Netherlands
Tel: +31 (0)317 681 040
Email: info@hendi.eu

References

• Welkom - HENDI Tools for Chefs
• Home - Serviceworld

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>