LG WDP6B Steel Pedestal Storage Drawer Owner’s Manual
- June 3, 2024
- LG
Table of Contents
LG WDP6B Steel Pedestal Storage Drawer
IMPORTANT: Read and follow these instructions.
NOTICE required work. The installer must have electrical and mechanical
training and acceptable knowledge in Safety is foremost—both your own and that
of other
people. Many important safety instructions are provided in this instruction
and your appliance. Always read and observe all safety instructions.
WARNING
Excessive Weight Hazard Two or more people may be needed to install and move
the appliance and pedestal assembly. Do not allow children to play in the
drawer. Do not step on the handle
NOTE
A firm, solid floor is even more critical to a front-loading washer than to a top-loader. If your floor is wooden and /or framed in construction, you may need to reinforce it. Front loaders have substantially faster spin speeds than top loaders, causing greater vibration. If the floor is not solid, your washer will vibrate.
NOTE
If a drip pan must be used, take extra care to follow the instructions provided with the drippan and make sure the leveling feet are adjusted for the firm and even contact with the pan. The use of drip pans and failure to properly level the machine may result in increased vibration and noise during operation.
Check the width of the pedestal before purchasing to make sure that it matches the width of your appliance (27″ (70 cm) or 29″ (74 cm)).
Included Accessories
Tools Needed
WASHER/COMBO INSTALLATION
-
Remove the pedestal, installation hardware, and instructions from the shipping carton.
-
Before installing the pedestal, remove foreign objects on the floor and clean the floor. Dust, water, oil, detergent, and so on could cause vibration due to bad contact of the legs with the floor.
-
Level the pedestal in a clean place by adjusting the feet. NOTE
Do not extend the legs any more than necessary to level the washer. The more the legs are extended, the more the washer will vibrate.
After the washer is leveled, tighten the lock nuts up toward the base of the washer using the wrench. All four lock nuts should be tightened. -
Position the washer/combo on top of the pedestal.
NOTE
Because of the weight of the washer/combo, two or more people may be needed.
NOTE
If the washer or combo was previously installed, unplug it, disconnect the inlet hose (s)from the faucet (s), disconnect the drain hose, and drain all hoses. -
Level the washer/combo on the pedestal by adjusting the feet
-
Make sure the holes on the pedestal align with the holes in the appliance, then install 4 screws at each corner to securely attach the appliance to the pedestal.
NOTE
If the screws are not installed properly, noise and vibration may result. For WASHER: 16 SCREWS For DRYER: 8 SCREWS -
Move the washer/combo to the desired place.
NOTE
The appliance and pedestal assembly must be placed on a solid and level floor for proper operation. Adjust the legs of the appliance and pedestal by turning with a wrench. Then, adjust the lock nut toward the pedestal while holding the pedestal leg using a wrench.
NOTE
Diagonal Check: When pushing down the edges of the washing machine top plate diagonally, the machine should not move up and down at all. (Please check both directions.) If the machine rocks when pushing the machine top plate diagonally, adjust the feet again.
NOTE
To make sure that the washer is properly level, run the washer with a test load: place approximately 6 pounds of laundry in the machine. Then press POWER, press RINSE+SPIN, and then press the START/PAUSE button. See the following sections for additional information on cycle selection and operation. Verify that the washer does not rock or vibrate excessively during the spin cycle. If the washer vibrates or shakes, adjust the leveling feet until the washer is stable and retest.
DRYER INSTALLATION
-
Remove the pedestal, installation hardware, and instructions from the shipping carton.
-
Insert the T-clip of the 4 retainers into the dryer base as shown. Press up on the back of the clip and pull outward to lock it into place.
-
Position the dryer on top of the pedestal.
NOTE
Because of the weight of the dryer, two or more people may be needed.
If the dryer was previously installed, uninstall it as follows:
Uninstalling an electric dryer:
Unplug the power supply cord,
Pull the dryer away from the wall enough to loosen the vent clamp. Loosen the clamp and carefully remove the exhaust vent from the dryer exhaust outlet.
B. Uninstalling a gas dryer:
Unplug the power supply cord.
Turn off the gas supply.
Pull the dryer away from the wall enough to loosen the vent clamp. Loosen the clamp and carefully remove the exhaust vent from the dryer exhaust outlet. -
Make sure the holes on the pedestal align with the holes in the appliance, then install 2 screws at each corner to securely attach the appliance to the pedesta.
NOTE
If the screws are not installed properly, noise and vibration may result. -
Move the dryer to the desired place.
NOTE
The appliance and pedestal assembly must be placed on a solid and level floor for proper operation. Adjust the legs of the appliance and pedestal by turning with a wrench. Then, adjust the lock nut toward the pedestal while holding the pedestal leg using a wrench.
Using Laundry Basket or Drawer Divider
- Organize the storage space using the laundry basket or the drawer divider.
- The laundry basket and the drawer divider cannot be used at the same time.
WARRANTY
LG Electronics Inc. Will repair or at its option replace, without charge, your product if it proves to be defective material or workmanship under normal use during the warranty period set forth below, effective from the date of the original consumer purchase of the product. This limited warranty is good only to the original purchaser of the product and effective only when used in the United States including Alaska, Hawaii, and U.S. Territories; and Canada.
WARRANTY PERIOD: | HOW SERVICE IS HANDLED: |
---|---|
1Year from the Date of Purchase. | Call |
1-800-243-0000 (USA) or 1-888-LG CANADA and choose the appropriate prompt. Please have the product type, model number, serial number, and ZIP code ready.
THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. TO THE EXTENT ANY IMPLIED WARRANTY IS REQUIRED BY LAW, IT IS LIMITED IN DURATION TO THE EXPRESS WARRANTY PERIOD ABOVE. LG WILL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INDIRECT, OR INCIDENTAL DAMAGES OF ANY KIND, INCLUDING LOST REVENUE OR PROFITS, IN CONNECTION WITH THE PRODUCT. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR THE EXCLUSION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.
THIS LIMITED WARRANTY DOES NOT APPLY TO:
- Service trips to your home to deliver, pick up, and/or install the product, instruct, or replace house fuses or correct wiring, or correction of unauthorized repairs; and
- Damages or operating problems that result from misuse, abuse, operation outside environmental specifications or contrary to the requirements or precautions in the Operating Guide, accident, vermin, fire, flood, improper installation, acts of God, unauthorized modification or alteration, incorrect electrical current or voltage, or commercial use, or used for other than intended purpose.
- Therefore, the cost of repair or replacement of such a defective product shall be borne by the consumer.
CUSTOMER INTER-ACTIVE CENTER NUMBERS
To Prove Warranty Coverage
| ****
Retain your Sales Receipt to prove the date of purchase.
A copy of your Sales Receipt must be submitted at the time warranty service is provided.
---|---
To Obtain Nearest Authorized Service Center or Sales
Dealer, or to Obtain Product, Customer, or Service Assistance| Call
1-800-243-0000 or 1-888-LG CANADA and
choose the appropriate prompt from the menu, and have your product type, model
number,
serial number, and ZIP Code; or visit our website at
- MODEL : 27” LWP-27F0 / WDP6
- Net weight: 52.9 lb (24 kg)
- Specifications are subject to change by the manufacturer.
- Données techniques sujettes à changement sans préavis
- Las especificaciones son sujetas a cambio por el fabricante
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>