ANYCUBIC Photon 3D Printers User Manual
- June 7, 2024
- Anycubic
Table of Contents
Anycubic 3D User Manual
-
Before using: ensure the antenna has been installed.
-
Connect the printer to a smartphone by APP (instruction below)
- Connect WIFI to 3D printer: Enter the WIFI account and WIFI password with
the format below In file WIFI.txt, print this file and the machine would
connect WIFI automatically.
Note:
a. The name and format of the file WIFI.txt cannot be changed.
b. The account and password should not contain exotic letters and should
not be more than 20 characters.
c. If the WIFI doesn’t have a password, enter NONE in ‘WIFI Password” and 0
in ‘Settings”; otherwise, enter I in “Settings”.
d. Enter the account and password without space to punctuation marks. Those
punctuation marks must not be deleted.
2) Add the device on APP:
-
Check IP address of the device
-
Add the device by clicking “User —.”Device List”
-
Connect the device:
Note:
a. The smartphone and 3D printer must connect to the same WIFI.
b. Multiple types of devices can be added to the devise list, but only one can
be connected at a time.
- File
- Click “File” on the bottom menu bar, check and preview the model file on a USB memory stick that is connected to a 3D printer.
- Swipe left to delete the file; long press to select files to delete.
- Click to select the model and then click the image . on the right side of the Ale to enter the Print interface.
- Print control and parameters setting
-
Start, pause and stop
-
Click the icon on the top right corner to set printing parameters
