ANYCUBIC Kobra 2 3D Printer User Guide

ANYCUBIC Kobra 2 3D Printer

Machine Installation

The TF card of the machine comes with an instruction video.

Note: Please install the PEI sheet.

Check Before Use

1. Pulley elastic adjustment Check if the print head is shaking. If it is, adjust the hexagonal isolation column located underneath the print head until it slides smoothly and without shaking.
2. Check if the print bed is shaking. If it is, adjust the hexagonal isolation column located underneath the print bed until it slides smoothly and without shaking

The gantry’s pulleys on both sides also have corresponding eccentric isolation columns that can be adjusted.

Belts
Please manually move the print head and print platform. If there is any difficulty or abnormal noise during the movement, adjust the tensioner to ensure smooth sliding of the print head or platform.

Voltage adjustment
Please confirm whether the input mode of the voltage of the power box is correct, and adjust to the appropriate voltage level according to the local voltage usage.

Leveling

1. Connect the printer to a power outlet with the power cable, then power on the printer.
2. Click on the screen [Prepare] – [Leveling] – [Auto Leveling]. Wait for the machine to be leveled.

Loading Filament

1. Click on [Prepare]-[Filament]-[Filament In]. The heating interface will appear, click “OK”.
2. Click [Filament In] again, wait until the filament starts to extrude from the nozzle, and select [Stop] to end the filament loading process.

Note: Before inserting the filament into the extruder, make sure the end of the filament has been straightened.

Start printing

1. Insert the TF card into the card slot of the printer.
2. Click [Print] on the main menu and select the model file.
3. hen the nozzle and heating bed reaches a preset temperature, the machine begins to print.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>