NYZ Apollo1 User Guide
- June 7, 2024
- NYZ
Table of Contents
Apollo1
Product Overview
| 
---|---
Bluetooth Connection
Step 1
Pick up the two earbuds from the charging case. Pull off the protective film.|
---|---
Step 2
Put them in and take them out.| 
Step 3
Turn on the Bluetooth of the device, search for the Bluetooth name: Apollo
1, click it to connect.
Disconnection
Step 1
Put the earbuds into the charging case. The Bluetooth connection will end.|
---|---
Step 2
Alternatively, tap on the turn off the Bluetooth function on your device.|
Note: When you take out the earbuds from the charging case, they will connect with the most recently connected device.
**When You Just Use To The Left Earbuds
**
When you using the left earbuds alone for the first time:
Step 1
Take out the left earbuds|
---|---
Step 2
Select the new search for the bluetooth name: Apollo 1, click it to connect.|
Note: When you take out the left earbuds from the charging case after first time used the left earbuds alone, they will connect with the most recently connected device.
Tap Operation
Power on： White light holding 1 seconds
Power off： Red light holding 1 seconds
Note: The earbuds will automatically shut down after entering BT pairing for 2 minutes.
Charging And Working Time
Reset
The earbuds needs to be reset in the following situations:
- The earbuds cannot be paired automatically.
- The earbuds cannot be connected to bluetooth due to in correct operation.
- Try resetting when one headset is not working but the indicator is charging properly.
- Mismatch of headset connected devices.
- You can try to reset it in any case when it is not working.
Step 1
Place the earbuds in the charging case.|
---|---
Step 2
Hold on the multifunction touch for 3 seconds to power
on both the earbuds.| 
S tep 3
Put off your hands.|
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>