Shark ROCEKT PRO Powerfins Cordless Vacuum User Guide
- June 7, 2024
- Shark
Table of Contents
Shark ROCEKT PRO Powerfins Cordless Vacuum User Guide
sharkclean.com/support
registeryourshark.com
WHAT’S INSIDE:
- (A) Handheld Vacuum
- (B) PowerFins Floor Nozzle
- (C) Wand w/Handheld Storage Clip
- (D) Crevice Tool
- (E) Upholstery Tool
- (F) Charger
- (G) Anti-Allergen Brush
- (H) Li-Ion Battery (Pre-Installed)
- (i) HEPA Post-Motor Filter (Pre-Installed)
ASSEMBLY
For complete maintenance instructions, see the enclosed Owner’s Guide. For additional parts and accessories, visit sharkaccessories.com. For additional batteries and charging accessories, visit sharkclean.com/batteries.
POWER SETTINGS
OFF
Slide switch to the top to turn off power. To begin vacuuming in Standard Mode, slide switch to the appropriate setting.
BARE FLOOR SETTING
Bare Floor/Area Rugs Slide switch to the middle. The brush roll spins slowly to clean bare floors and small area rugs.
CARPET SETTING
Carpet Slide switch to the bottom. The brush roll spins faster to pick up debris below the surface of your carpets.
BOOST MODE
For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the trigger to go into Boost mode.
NOTE: Select Carpet setting for stuck-on dirt and debris.
CHARGING
Easily Insert or Remove the Li-Ion Battery
To insert, slide the Battery into the slot in the back of the handheld vacuum.
To remove, press and hold the Battery Release Button then slide out the
battery.
LI-ION BATTERY
NOTE: Full charge takes approximately 3 hours.
NOTE: The battery comes partially charged. Charge fully before first use.
Battery Runtime
VERSATILE CLEANING
Slide the power button to the desired power setting. Place your foot on the floor nozzle and tilt the handheld vacuum back.
NOTE: Brush roll will only engage when the handle is tilted back.
To detach the wand for above-floor cleaning, stand the vacuum upright, then press the Nozzle Release button on the bottom of the wand and pull the wand up to disconnect it.
OR
To detach the handheld vacuum, press the Wand Release button and lift the
handheld vacuum off the wand.
THEN
Attach a cleaning accessory, then choose the power setting.
EMPTYING THE DUST CUP
@sharkcleaning
© 2020 SharkNinja Operating LLC. ROCKET and SHARK are registered trademarks of SharkNinja Operating LLC. CLEANTOUCH is a trademark of SharkNinja Operating LLC.
IZ362H_QSG_MP_Mv4_200820
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>