FISHMASTER Pro Series T-Top Instruction Manual

FISHMASTER Pro Series T-Top Instruction Manual

Included Hardware Identification

• 8x
  

• 4x

• 8x

• 16x

• 16x

• 12x (Actual Size)

• 18x

• 10x
  

• 4x
  

Parts List:

1. (5) Canopy Coupler
2. (4) Canopy Sections
3. (4) Leg Sections
4. (4) Upright Caps
5. (2) Standoffs
6. (2) Allen Keys
7. (2) Nylon Washers
8. (1) Canvas Cover
9. (1) Rope
10. (1) 3M 5200 Adhesive Tube
11. (1) Marine Lubricant

Gather Additional Tools and Materials

CAUTION: If you are unfamiliar with your boat’s construction, please seek professional advice before installing the t-top.

For added assistance when installing the t-top, please consider watching the installation video at: fishmaster.com Or call us at 877-777-8693

As you plan to install the, Fishmaster Pro Series T-Top, keep in mind that drilling into the console and deck of the boat is needed in order to safely secure the t-top to the boat.

Step 1: Assemble Side Sections

Hardware Needed:

PRO TIP: Get the bolts  snug in place first, then come  back to tighten down fully after each step.

1. Attach leg sections together with the hinge facing the bow of the boat.

2. Insert the M10x35 bolts to connect the top and lower sections.
   

3. Insert the nylon washer followed by the hinge bolt and lock nut into the hinge.
   

Step 2: Positioning The Assembled Legs

1. It is important to understand the placement of the legs will need to be square and even with the opposite side of the console.
   
   PRO TIP: It is recommended to place the leg 1”-7” away from the sides of the console.

Step 3: Mounting Legs To Boat

Hardware Needed:

1. Mark the holes to know where to drill.

2. DRILL IN REVERSE, and use a 45 degree chamfer drill bit to prevent gel coat damage.
   

3. Attach leg sections to the boat by applying 3M 5200 marine adhesive between and in the holes. Then screw down the foot.

• Do not apply 3M 5200 adhesive to deck or screw holes until parts 1-2 of Step 3 is completed to both the front and rear feet.

Step 4: Assembling The Standoffs

1. Mark to know where to place the standoff.
   

2. Using a 3/8” drill bit, drill a hole through the side upright.

3. Place the standoff rod through the hole and mark where it touches on the console. Use 14” long 3/8” Drill Bit.
   

4. Measure standoff and cut with a fine tooth handsaw to the appropriate length.

5. Assemble the standoff through the leg and from the inside of the console.
   

Step 5: Repeat Steps 1-4 For Second Leg

1. Repeat steps 1-4 to properly assemble the second leg and mount it to the deck.

• Step 1

• Step 2

• Step 3

• Step 4

Step 6: Assemble The Canopy

Hardware Needed:

1. Gather the parts to the canopy.
   
   Note: If the coupler is in a colored bag, that is the designated rear coupler

2. Insert the double ended canopy couplers into the inner/outer rails
   

3. Install bolts to join the canopy sections together.
   

4. Remember to install the hinge bolts.
   

• Install the canopy to the legs by resting it into the c-clamp and tilting it forward.
  

• Insert the bolts into the c-clamps.
  
  PRO TIP: It is recommended to get assistance in placing the canopy onto the legs.

Step 7: Attaching the Canvas Top

1. Slide the canvas top onto the canopy of the tower. Make sure the white I.D. tag is facing the rear and on the underside.
   

2. Keep the canvas in place by first attaching cableties. Maintain an even spacing between the canvas and the tubes.
   

3. Thread the rope through each grommet and over the bars as shown below. Remove the cable-tie afterwards.
   
   PRO TIP: With a firm tug, tighten the canvas down like a drum head.

Final Product

Congratulations,
You have just successfully installed your new Fishmaster Pro Series T-Top!
Send us a picture of your install out on the water to our gallery on Fishmaster.com and we will send you a FREE t-shirt!
Tag us on social media to be featured on our feed! Welcome to our fishing team!

Contact Us

Do you have questions? Call us @ 877.777.8693 Monday – Friday, 8am-5pm EST

Follow us on:

@fishmasterinc

fishmasterinc

References

• Boat T-Tops - Universal T-Top Accessories | Fishmaster Find A Dealer Icon Support Icon

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>