Roccat ELO 7.1 USB User Manual and Driver

: June 7, 2024
: ROCCAT

Table of Contents

Roccat ELO 7.1 USB
PACKAGE CONTAINS
HEADSET CONTROLS
PC/MAC® SETUP
TECHNICAL FACTS
REGULATORY COMPLIANCE STATEMENTS FOR THE ELO 7.1 USB
EUROPEAN UNION AND EUROPEAN FAIR TRADE ASSOCIATION (EFTA) REGULATORY
Operating systems:
DOWNLOAD
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Roccat ELO 7.1 USB

User Manual and Driver

Download Driver

PACKAGE CONTAINS

Removable Microphone
Elo 7.1 USB Gaming Headset

HEADSET CONTROLS

PC/MAC® SETUP

PC/MAC SETUP

Plug the Elo 7.1 USB in your PC
Right-click the speaker icon in your toolbar and select Sounds
Select the Playback devices tab
Right-click Elo 7.1 USB and select Set as Default Device
Open the driver software to customize your settings

TECHNICAL FACTS

TECH SPECS

Wired USBA cable connection
20Hz – 20kHz speaker frequency response
50mm speakers with neodymium magnets
Audio controls: master volume wheel, mic mute, mic monitor wheel
Removable unidirectional microphone
Leatherette headband with foam cushioning
Over-ear design featuring memory foam

SYSTEM REQUIREMENTS

Windows® 7, 8 and 10 (software support)
USB 2.0 (or higher)
Internet connection (for driver software)

Should you need assistance …
Our support team is ready to help you with any technical questions. Just send an e-mail to support@roccat.org or visit our website at: WWW.ROCCAT.ORG/SUPPORT

REGULATORY COMPLIANCE STATEMENTS FOR THE ELO 7.1 USB

FEDERAL COMMUNICATIONS COMMISSION (FCC) COMPLIANCE NOTICES

CLASS B INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15, Subpart B of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This product is compliant with the Consumer Product Safety Improvement Act of 2008, Public Law 110-314 (CPSIA)

CANADIAN ICES STATEMENTS
Canadian Department of Communications Radio Interference Regulations This digital apparatus does not exceed the Class B limits for radio-noise emissions from a digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.

TURTLE BEACH CORPORATION | 11011 VIA FRONTERA, SUITE A, SAN DIEGO, CA 92127
© 2020 Turtle Beach Corporation. All rights reserved. Any product names mentioned in this manual may be trademarks or registered trademarks and are the property of their respective owners. Information contained herein is subject to change without notice. Turtle Beach Corporation shall not be made liable for any errors that may appear in this manual. This publication or parts of it may not be reproduced without the express consent of the publisher.

EUROPEAN UNION AND EUROPEAN FAIR TRADE ASSOCIATION (EFTA) REGULATORY

COMPLIANCE

Declaration of Conformity Marking by this symbol.

indicates compliance with the Essential Requirements of the EMC Directive of the European Union (2014/30/EU). This equipment meets the following conformance standards:

Safety: EN 50332-2:2015, EN71-3:2013
Emissions: EN 55032:2015+AC:2016,
EN55035: 2017+AC:2019-11, AN/NZS CISPR32:2015
Immunity: EN55024:2010+A1:2015, AN/NZS
CISPR24: 2010+A1:2015

The products are licensed, as required, for additional country specific standards for the International Marketplace. Additional issued licenses available upon request.

Environmental: REACH 2006/1907/EC, RoHS 2015/863 amending Annex II to Directive 2011/65/EU, WEEE 2012/19/EU, Packaging 94/62/EC, Toys Safety Directive 2009/48/EC

Please visit the following URL for a complete copy of the Declaration of Conformity: http://www.turtlebeach.com/homologation

This symbol on the product or its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste for recycling, please contact your local authority, or where you purchased your product.

Turtle Beach Europe Ltd is obligated as a producer with a main activity of selling under The Producer Responsibility Obligations (Packaging Waste) Regulations 2007. To fulfil our obligation we are registered with Comply Direct and their Recycling Room. Here you will find advice and information on packaging waste management, recycling symbols and the waste hierarchy principles of reduce, reuse and recycle. https://www.complydirect.com/the- recycling-room/