IKEA TRADFRI 10W Driver for Wireless Control Instructions
- June 7, 2024
- Ikea
Table of Contents
IKEA TRADFRI 10W Driver for Wireless Control Instructions
HOW TO STEER YOUR LIGHTING
The switch on your power supply cord will make it possible to turn ON/OFF all products connected to the TRÅDFRI driver, but if you want to dim or connect your products to IKEA Smart lighting products, you need to buy a separate TRÅDFRI steering device (e.g. a remote control).
The TRÅDFRI steering device needs to be paired with your TRÅDFRI driver/s. If you have more than one (1) driver you can pair each one with the steering device, so that the entire combination can be turned ON/OFF or dimmed at the same time.
Depending on how easy it will be to access the driver please consider to pair the TRÅDFRI driver/s with your steering device before the final placement of the driver/s and cords.
PAIRING A STEERING DEVICE TO YOUR DRIVER
- Connect at least one (1) product to the driver before you begin the pairing. Make sure that the power supply cord is connected to a power socket and that the switch on the cord set is turned ON.
- Locate the pairing symbol on the driver. Hold the steering device close to the pairing symbol (no more than 5 cm away).
- Press and hold the pairing button on the steering device for at least 10 seconds. A red light will shine steadily on the steering device. The product connected to the driver will begin to dim and flash one time to indicate that the driver is being paired to the steering device
HOW TO FACTORY RESET YOUR DRIVER
If the driver does not respond or if you want to un-pair the driver from a steering device you might have to make a factory reset. The driver is forced to factory reset by carefully inserting a paper clip end or similar in the small hole (marked RESET) in the driver enclosure and applying a slight pressure.
IMPORTANT!
- The driver is for indoor use only and can be used in temperatures ranging from 5ºC to 45 ºC (41ºF to 113 ºF).
- Do not leave the driver in direct sunlight or near any heat source, as it may overheat.
- Do not subject the driver to wet, moist or excessively dusty environments as this may cause damage.
- The declared radio range between the driver and the steering device is measured in open air. Different building materials and placement of the units can affect the wireless connectivity range.
CARE INSTRUCTIONS
To clean the driver, wipe with a dry soft cloth. Never use abrasive cleaners or chemical solvents as this can damage the product.
PRODUCT SERVICING
Do not attempt to repair this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks.
TECHNICAL DATA 10W
Type: ICPSLC24-10NA-IL-1
Input voltage: 100-120Vac, 50/60Hz
Output voltage: 24Vdc
Max output power: 10W
For indoor use only
Range: 10 m in open air.
Operating frequency: 2405-2480 MHz
Output power: 14 dBm
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Almhult, SWEDEN
This device complies with Part 15 of the FCC Rules.
This device contains license exempt transmitter(s)/receiver(s) that comply
with Innovation Science and Economic Development Canada’s license exempt RSS
standard(s). Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation of the device.
WARNING:
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE INFORMATION
According to RF exposure regulations, under normal operations the end user shall refrain from being closer than 20 cm from the device.
License rights and limitations
NO RIGHTS OR LICENSES, EXPRESS NO RIGHTS OR LICENSES, EXPRESS OR IMPLIED, ARE GRANTED TO USE THIRD-PARTY DEVICES IN COMBINATION WITH THESE PRODUCTS IN A WIRELESS MESH NETWORK, OR TO USE THIRDPARTY SERVICES TO ACCESS, MONITOR OR CONTROL THESE PRODUCTS IN A WIRELESS MESH NEWORK VIA THE INTERNET OR ANOTHER EXTERNAL WIDE AREA NETWORK
For use pursuant to U.S. Patent Nos.:
US 6,914,893
US 7,697,492
US 8,964,708
The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>