serenelife SLFPBAL Propane Gas Fire Pit Table User Guide

: June 7, 2024
: serenelife

Table of Contents

SAFETY INFORMATION
SAFETY INFORMATION
PARTS LIST
ASSEMBLY INSTRUCTIONS
OPERATION
To Light
To Extinguish
MAINTENANCE
TROUBLESHOOTING
What’s in the Box:
Features:
Technical Specs:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SLFPBAL
Propane Gas Fire Pit Table
40,000 BTU Round Gas Firepits with Cover for Outside
USER GUID serenelife SLFPBAL Propane Gas Fire Pit Table
-

DANGER
FIRE OR EXPLOSION HAZARD
If you smell gas:
• Shut of gas to the appliance.
• Extinguish any open flame.
• If odor continues, leave the area immediately.
• After leaving the area, call your gas supplier or fire department.
Failure to follow these instructions could result in a fire or explosion, which could cause property damage, personal injury, or death.
WARNING:
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.
WARNING:
If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or loss of life.
WARNING:
For outdoor use only. Installation and service must be performed by a qualified installer, service agency, or gas supplier.
WARNING:
Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appliance. For assistance or additional information consult a qualified installer, services agency, or gas supplier.

INSTALLER:
Leave this manual with the appliance.
CONSUMER:
Retain this manual for future reference.

DANGER|

CARBON MONOXIDE HAZARD
This appliance can produce carbon monoxide which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed space such as a camper, tent, car or home.

---|---

SAFETY INFORMATION

Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so may result in a fire, explosion, injury or death.
WARNING

The installation of this unit must adhere to local codes or Propane Storage and Handling Code, CSA B149.2.
THIS UNIT IS INTENDED FOR OUTDOOR USE ONLY! This product shall be used outdoors, in a ventilated space and shall not be used in any enclosed area.
This unit is to be used with propane gas only! (sold separately)
Do not attach a remote gas supply to this unit.
Only use propane gas for this unit.
Solid fuels shall not be burned in this appliance.
When igniting this unit, stay away from the burner as the frame will light up and may cause injury.
LP GAS WARNING: Do not use any more than 1/4 in depth lava rocks/pumice tones/LavaGIass above the burner holes. Doing so will suffocate the frame.
If the propane gas tank is leaking gas, you may hear, see, or smell a hiss.

Do the following:

Disconnect the propane gas tank.
Do not attempt to fix the problem yourself.
Contact your gas supplier or fire department for help.

Applying too much propane may result in gas pooling and will not burn.
Allow fresh air into the unit so that the remaining gas may escape.
Do not use a flame to check for gas leaks.
Manifold pressure: 11-inch w.c. (2.74kPa).
Use LP propane tanks with the following dimensions: diameter 12 in, height 18 incapacity 20 lbs.
You must use a propane tank that has a collar to protect the gas valve.
DO NOT fill tank over 80 percent full.
The tank system must be set up for vapor withdrawal.
Discontinue use if any part of the propane tank is damaged. Rust and dents may be hazardous and should be inspected by a gas supplier.
Do not burn anything other than the provided materials for this fire table.
Keep away from the unit for the first 20 minutes after igniting your unit for the first time, as lava rocks/pumice stones/LavaGlass could pop out and cause injury. Should any rocks pop out, discard them.
Always ensure that lava rocks/pumice stones/LavaGlass/Blue glass beads are completely dry before use. Failure to do so will cause them to crack or pop.
Do not operate the unit until all parts are fully assembled.
Do not paint or color any part of this heating unit.
The unit may be hot while in use, do not attempt to move it while in use.
Never leave this heating unit unattended while in use.
This unit is not intended for cooking.
Keep any flammable items away and do not use any other fireplace cover for this unit.
Keep a safe distance to avoid burning skin or clothing.
Do not sit or rest hands or feet on this heating unit.
Never place hands or fingers on the upper portion of this unit while in use.
Keep all electrical cords and fuel supply hoses away from heated surfaces.
Combustible material should not be within 60 inches of the top of the unit, or within 48 inches around the entire unit.
Keep the appliance area clear and free from combustible material, gasoline, and other fammable vapors and liquids.
If the frame goes out while burning, turn the gas valve off. Wait 5 minutes before repeating the initial lighting procedure.
Once you have fame started, hold down the control knob for 1 minute.
Do not add water into the unit.
Do not operate the unit if any part has been underwater. Immediately call a qualified service technician to inspect the appliance and replace any part of the control system and any gas control that has been underwater.
Do not disconnect any part while the unit is in use.
Do not store a spare propane tank on or near this unit.
If the heating unit is indoors, detach the propane tank and leave it outdoors.
Always remove the protective cover before operating (if applicable).
Do not set the protective cover over the unit until it is turned off and completely cooled down.
Check for leaks after not using the unit for long periods of time.
Children should never operate this unit. Children must be supervised while near this unit.
Maximum gas supply: 250 psi; Min. gas supply: 10 psi.
All installation and repair should be done by a qualifed professional.
This unit should be inspected annually and cleaned regularly.
Inspect all elements of this heating unit before each use. If there is damage, the burner must be replaced.
Keep the hose out from any pathways to eliminate any accidental damage. (if external tank).
Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or injury.
The gas supply tank should be constructed and marked with specifications for the LP gas tanks of the U.S. Department of Transportation or the National Standard of Canada CAN/CSA-B339, LP gas tanks, spheres, and Tubes for Transportation of Dangerous Goods; and Commission.
The LP gas tank must have a listed overfilling prevention device and a QCCI or Type I, (CGA791) LP gas tank connection.
This heating appliance should not be used on plastic or artificial wood decks.
Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.
Young children should be carefully supervised when they are in the area of the appliance.
Clothing or other flammable materials should not be hung from the appliance or placed on or near the appliance.
Any guard or other protective device removed for servicing the appliance shall be replaced prior to operating the appliance.
Installation and repair should be done by a qualified service person.
The appliance should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It is imperative that the control compartment, burners, and circulating airways of the appliance are kept clean.

IF APPLICABLE:

Allow the heating item to cool completely before placing it on the lid.
DO NOT use the heating item while the lid is installed. Always remove the lid while the heating item is in use.

SAFETY INFORMATION

Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied directly by SereneLIfe.
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate the appliance. For assistance with repair or replacement of the burner or any other parts, contact to us.
NOTE: You must follow all steps to properly assemble this heating item.
Make sure the gas valve is turned “OFF” before assembling. Do NOT attempt to assemble without proper tools.

serenelife SLFPBAL Propane Gas Fire Pit Table
-assemble

PARTS LIST

serenelife SLFPBAL Propane Gas Fire Pit Table -PARTS
LIST

ITEM	SPECIFICATION	QTY
1	Body	1 PC
2	Guard	1 PC
3	Thermocouple	1 PC
4	Ignition Pin	1 PC
5	Corrugated Pipe	1 PC
6	Gas valve	1 PC
7	Burner	1 PC
8	Regulator hose	1 PC
9	Reducing Nipple	1 PC
---	---	---
10	Control Knob	1 PC
11	Ignitor	1 PC
12	Groundwire	1 PC
13	Blue glass beads	1 Box
14	PVC cover	1 PC
15	Battery (AAA)	1 PC

serenelife SLFPBAL Propane Gas Fire Pit Table -OFF

Check that the control knob for the gas supply system is turned to the “ OFF ” position before starting any assembly.

serenelife SLFPBAL Propane Gas Fire Pit Table -2

Turn the cylinder valve on the tank clockwise to close the propane tank. Attach the preassembled regulator from the Body to the cylinder valve by turning the regulator coupling nut clockwise. Make sure it is fastened securely and tighten connections by hand only.
Remove the rubber cap on the electronic igniter by unscrewing and slide the battery into the battery slot. Make sure the positive side of the battery faces outwards. Screw the electronic igniter cap over the battery tightly.

ASSEMBLY INSTRUCTIONS

Pour the box of lava rocks into the fire bowl.
CAUTION
To ensure proper function, the guard on this burner should be free of Blue glass beads at all.

serenelife SLFPBAL Propane Gas Fire Pit Table - Blue glass
beads

OPERATION

Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “off” position. Spray or brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles occur on any connection there may be a leak. If you smell gas or a leak is discovered turn the gas valve off, disconnect the propane gas tank, and do not use the appliance until the leak is repaired.
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion you must replace the hose (if applicable). Pumice stones/lava rocks/LavaGlass/Blue glass beads could pop up and strike somebody’s face during the process of lighting this unit; stand away from the unit for the first 20 minutes after igniting. Flame height should be a yellow/blue color between 2 – 10 inches in height.
Wait 50 minutes after extinguishing fame prior to placing a lid (if applicable) or protective cover on the heating item.

To Light

Make sure the control knob is in the “OFF” position.
Open the door and slowly open the valve on the propane gas tank by turning the knob counterclockwise.
Close the door on the body.
Push and hold in the electronic ignitor to create sparks within the electrode, continue to hold.
Push in the control knob and turn to the “HIGH” position. Keep holding down the control knob to allow gas to flow for 15 seconds.
If ignition doesn’t occur within a few seconds release the control knob and rotate to the “OFF” position. Wait for 5 minutes for gas to clear and then repeat the above lighting instructions.
Once there is lit, the flame intensity may be controlled by turning the control knob between the “LOW” and “HIGH” positions.

To Extinguish

Turn the control knob clockwise to the “HIGH” position; let the knob pop up and continue turning the control knob to the “OFF” position.
Close the cylinder valve on the propane gas tank if you don’t intend to use it for a long time.

MAINTENANCE

Before performing any maintenance always disconnect the propane gas tank.
Store your product indoors during the winter months. Avoiding extreme cold temperatures will prevent exposure damage.
Keep the heating item free and clear from combustible materials.
Visually inspect burner for obstructions and keep tank enclosure free and clear from debris.
Use a soft brush to get rid of the mild stains, loose dirt, and soil after the burner and pumice stones/lava rocks/Lava Glass/Blue glass beads are completely cooled down. Wipe down with a soft cloth.
Harsh weather conditions may cause stubborn stains, discoloration, and possibly rust pitting.
Permanent damage may occur if powder or solvent comes in contact with painted or plastic components on this heating unit.
Keep the heating unit stored away from direct sunlight.
If storing this unit inside, disconnect the propane gas tank from the gas valve.
Not using manufacturer-approved or supplied parts/accessories may result in a defective condition and void the warranty of this heating unit.
If desired, cover fire pit to protect exterior surfaces and to help prevent build-up in air passages.

Note: Wait until the fire pit is cool before covering.

TROUBLESHOOTING

Problem	Cause	Solution
The heating unit won t light	Igniter pin and burner are wet	Dry off with a

soft cloth
Igniter battery is incorrectly inserted| Check which direction the battery is inserted
Igniter pin is broken| Contact us for parts replacement
Electrode wire is loose or disconnected| Reconnect wire to the igniter box located inside the fire pit behind the igniter box
Electrode wire is shorting between valve and igniter pin| Contact us for parts replacement
Burner won’t light while using a match| No gas flow
isn’t empty| Check that the gas tank
The regulator isn’t connected securely to the tank| Tighten regulator connection to the gas tank
Gas flow is obstructed| Check all hoses for kinks and bends
Burner ports are clogged| Turn all gas flow connections off. Insert an opened paperclip
(or similar item) into each of the burner ports to clear them out.
The heating unit emits a lot of blacks smoke| Flame is obstructed at burner ports| Check that all burner ports are free of any small lava rocks/pumice stones/ LavaGlass pieces
The regulator hose is kinked| Straighten hose of all bends or kinks
A sudden drop in gas flow| No gas flow| Check that the gas tank isn’t empty
---|---|---
The excess flow safety valve has been activated| Turn the control knob to the off position. Close the tank valve and disconnect the propane gas tank. Turn the control knob to ‘high”, wait 1 minute. Turn the control knob back to the off position. Reconnect propane gas tank.
Light the fire unit as indicated in the ‘To Light’ section of this manual.
Flame blows out easily| High or gusting winds| Increase the flame to ‘high’
No gas flow| Check that the gas tank isn’t empty
Excess flow safety valve has been activated| See sudden drop in gas flow’ above

What’s in the Box:

• 201 SS Burner
• Copper Injector
• Control Knob
• Gas Valve
• Igniter
• Corrugated Pipe| • Thermocouple
• Fire Pin with Protective Guard
• PVC Cover
• Blue glass beads
• User manual
---|---