ABLEWARE 72588-2000 Extra Wide Tall-Ette Toilet Seat Instructions
- June 7, 2024
- ABLEWARE
Table of Contents
INSTRUCTIONS
Extra Wide Tall-Ette® Toilet
Seat with Steel Frame
72588-2000
- Insert the two safety bars into the four holes in the top of the plastic seat.
- Push the four rubber feet onto the ends of the safety bars.
Note: Dipping the rubber feet in soapy water will make them slide on easier.
To install on toilet:
- Loosen nuts on the screws that hold the toilet seat and lid to the toilet.
- Lift the toilet seat to a raised position and pull up on it so there is a small gap between the seat and the toilet.
- Slide the Lok-in-El® Bracket tongue under the seat bracket so that the middle section fits between the toilet seat screws and the two narrow sections fit outside the screws.
- Tighten the nuts on the screws to secure the seat and bracket. The Tall-Ette® should be in contact with the bowl. The bottom flange fits inside the rim of the toilet bowl.
Caution:
- Do not use this model without the Lok-In-El® Bracket.
- Do not remove the Lok-In-El® Bracket.
- Do not use the Tall-Ette® Elevated Toilet Seat if it does not fit into the toilet bowl rim.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>