SP Ableware 72588-1000 Extra Wide Tall Ette Toilet Seat with Arms and Aluminum Legs Instructions
- October 27, 2023
- SP Ableware
Table of Contents
SP Ableware 72588-1000 Extra Wide Tall Ette Toilet Seat with Arms and
Aluminum Legs
INSTRUCTIONS
-
Insert the two safety bars into the four holes in the top of the plastic seat.
-
Push the four rubber feet onto the ends of the safety bars.
( Note: Dipping the rubber feet in soapy water will make them slide on easier.) -
Turn the seat over and place the Lok-In-El® Bracket on the seat by pressing the two large pins into the two wells provided. Turn seat right side up. The flat bar on the Lok-In-El® Bracket will extend from the rear of the seat.
-
Lift the toilet bowl seat to the raised position.
-
Slip the flat bar of the Lok-In-El® Bracket under the hinge bar of the toilet seat.
The bottom ring of the elevated seat must fit inside the toilet bowl. -
Adjust the legs so the seat sits firmly on the bowl and the legs rest on the floor.
Note: Once installed, if you find that the legs do not reach the ground simply cut some of the foam tubing from the arms. This will allow the seat to slide further up the legs. See instructions on the back. -
The seat is now ready for use. It may be cleaned by using a mild detergent solution and sterilized with alcohol.
Caution: Do not use this product without the Lok-In-El® Bracket. Do not use this product if the seat does not fit inside the toilet bowl rim.
Cutting the Foam Tubing:
If the legs do not reach the ground after installing, simply cut some of the
foam tubing from the arms. This will allow the seat to slide further up the
legs.
To do this
-
Measure the distance between the floor and the legs. Whatever the distance is, you will need to cut that much off of the bottom of the foam tubing on each arm.
So, if the distance between the floor and the legs is 1″ (2.54 cm), you will need to cut off 1″ (2.54 cm) of the tubing on each arm.
-
With a ruler, measure 1″ (2.54 cm) from the top of the elevated toilet seat up the arm and mark the tubing. Do this for all four legs.
-
Cut the tubing using a sharp knife or box cutter.
Note: Always cut tubing from the part closest to the top of the elevated toilet seat. Do not cut from the top of the armrests.
Your opinion counts! Write a product review at www.sp- ableware.com
Maddak Inc., a part of SP
661 Route 23 South, Wayne, NJ 07470 USA
Tel: (973) 628-7600 |
[email protected]
sp-ableware.com
Individual use varies. Maddak Inc./SP assumes no obligation or liability for any advice furnished by it or for results obtained with respect to these products. All advice is given and accepted at the user’s risk. For warranty information visit www.maddak.com/pdf/warranty_card.pdf.