Knightsbridge LEDBAT Series Ceiling Light Batten Instruction Manual
- June 7, 2024
- Knightsbridge
Table of Contents
INSTALLATION & MAINTENANCE MANUAL
LEDBAT SERIES
GENERAL INSTRUCTIONS
these instructions should be read carefully and retained after installation by the end-user for future reference and maintenance. These instructions should be used to aid the installation of the following products:
LEDBAT9
LEDBAT17| LEDBAT22
LEDBAT26
---|---
SAFETY
- Installation of this luminaire should only be carried out by a qualified electrician or competent person to the latest Building and current IEE Wiring Regulations (BS7671)
- Please isolate mains prior to installation/maintenance
- Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the circuit cable, fuse, or circuit breaker
- Please note the IP (Ingress of Protection) rating of this luminaire when deciding the location for installation · This product is Class II double insulated
- This product series is IP20 rated
- This product is non-dimmable
INSTALLATION
Note – If this luminaire is being used in conjunction with external PIR or sensors, please confirm with the manufacturer of the sensors that they are compatible with LED luminaires.
-
Provide a suitable power supply to the required position of the luminaire
-
Mark the location of the fixing holes for the mounting clips. The mounting clips should be spaced so as to distribute the weight of the luminaire evenly
-
Drill the holes for the mounting clips ensuring not to infringe with any joists, gas/water pipes or electrical cables that may be hidden behind the surface
Important: Subject to the surface foundation material, ensure the correct fixings are used -
Connect the luminaire into the mains supply via the terminal block. Please see Fig 1and Fig 2
Fig1
Fig2
- Fix the luminaire to the mounting brackets
- Switch on the power supply and test for correct operation
GENERAL
The LED lamps fitted in this product are non-replaceable. The unit should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where facilities exist. Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents that may damage the fitting.
WARNING
This product must be disconnected from the circuit if it is subjected to any
high voltage or insulation resistance testing. Irreparable damage will occur
if this instruction is not followed.
WARRANTY
This product has a warranty of 5 years from the date of purchase. Failure to
install this product in accordance with the current edition of the IEE Wiring
Regulations, improper use, or removal of the batch codes will invalidate the
warranty. If this product should fail within its warranty period it should be
returned to the place of purchase for a free-of-charge replacement. ML
Accessories does not accept responsibility for any installation costs
associated with the replacement product. Your statutory rights are not
affected. ML Accessories reserve the right to alter product specifications
without prior notice.
ML Accessories LimitedLU5 5TA
www.mlaccessories.co.uk
SBSEP17_V3
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>