PROKORD LDT44-C012U Gas Spring Monitor Arm USB3.0 9kg Instruction Manual
- June 7, 2024
- PROKORD
Table of Contents
GAS SPRING MONITOR ARM
USB3.0 9KG
DUS-T44
Read the entire instruction manual before you start installation and assembly.
If you have any questions regarding any of the instructions or warnings,
please contact your local distributor for assistance.
CAUTION: Use with products heavier than the rated weights indicated may result
in instability causing possible injury.
- Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
- Safety gear and proper tools must be used. This product should only be installed by professionals.
- Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
- Use the mounting screws provided and DO NOT OVERTIGHTEN mounting screws.
- This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
IMPORTANT : Ensure that you have received all parts according to the
component checklist prior to installation. If any parts are missing or faulty,
contact your place of purchase for a replacement.
MAINTENANCE: Check that the product is secure and safe to use at regular
intervals (at least every three months).
To properly balance the arm with monitors mounted, adjust the spring tension
using the supplied Allen Key as follows:
First, position and firmly hold the arm horizontally as shown. Ask for
assistance should you require it.
To avoid damage to monitors or mount,
always keep the arm in a horizontal position while making adjustments. Again,
ask for assistance if required.
If the arm drops, turn the adjustment screw counter-clockwise until it stays
in a horizontal position.
If the arm rises , turn the
adjustment screw clockwise until it stays in a horizontal position.
DO NOT over-tighten the
screws.
Note: If the display does not stop at your desired position, tighten the screws as shown.
Note: If the display does not
stop at your desired position, tighten the screws as shown.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>