APOCALYPSE AP-M67AC 600 Watt 6.5 Inch Mid-Range Speakers Owner’s Manual
- June 3, 2024
- APOCALYPSE
Table of Contents
AP-M67AC 600 Watt 6.5 Inch Mid-Range Speakers
Owner’s Manual
INTRODUCTION
Thank you for purchasing this Deaf Bonce product! Our company is committed to
the creation of extremely loud sound systems with no loss of quality.
To ensure proper use, please carefully read through this manual before using
this product. It is especially important that you read and observe caution’s
in this manual. Please keep the manual in a safe and accessible place for
future reference.
SAFETY INSTRUCTIONS
-
Fasten the speakers properly when installing it in the vehicle. If the component is disconnected during driving, it may cause serious damage to the passengers of the vehicle or another vehicle.
-
Before installing the components, if possible store the product in it’s original package to avoid accidental damage to the product.
-
Be careful when installing and dismantling the speaker! Do not let the speaker drop to avoid damage of its moving parts.
-
When working with tools follow safety rules.
-
Before the installation switch off the head unit and all other audio devices to avoid their damage.
-
Make sure that the location of the speaker does not hinder the proper operation of mechanical and electrical devices of the vehicle.
-
Do not install components in places exposed to water, excessive humidity, high or low temperature, dust or dirt.
ATTENTION! The product may be operated at +5 °C (41F) to +40 °C (104F). In case of moisture condensation, let the product to dry. -
When performing plumbing, drilling or cutting works with the car, make sure that there is no wiring, brake lines, fuel pipe or other structural elements under the place of work. Follow the safety rules! Use protective glasses and gloves.
-
When stretching back the speaker cables make sure that they are not in contact with sharp edges or moving mechanical devices. Make sure that they are firmly fixed and protected over the entire length.
-
The diameter of the speaker cables must be selected in accordance with the length and applied power.
-
Never stretch the cables outside of the car and near the moving parts of the car. This can lead to destruction of the insulating layer, short circuit and fire.
-
To protect the cables use rubber gaskets if the wire passes through a hole in the plate, or other similar materials if it lies close to the parts exposed to heat.
CAUTION!!! High sound pressure can damage your health! Please use the common sense when controlling volume!
WIRING DIAGRAMS
Do not expose your amplifier to loads below the value predetermined by the
manufacturer. Various examples of connection types are given at the pages
below. Use these xamples to determine the required load impedance of your
connection.
Serial connection of the speakers
| voice coil | Total impedance |
|---|---|
| 4 Ohm x2 MR | 8 Ohm |
| Voice coil | Total impedance |
|---|---|
| 4 Ohm x3 MR | 12 Ohm |
| Voice coil | Total impedance |
|---|---|
| 4 Ohm x4MR | 16Ohm |
Parallel connection of the speakers
| Voice coil | Total impedance |
|---|---|
| 4 Ohm x2MR | 2Ohm |
| Voice coil | Total impedance |
|---|---|
| 4 Ohm x3MR | 1.33Ohm |
| Voice coil | Total impedance |
|---|---|
| 4 Ohm x4MR | 1Ohm |
Mixed connection of the speakers
| Voice coil | Total impedance |
|---|---|
| 4 Ohm x4MR | 4Ohm |
CAUTION!!! High sound pressure can damage your health! Please use the common
sense when controlling volume!
Use the table below to select the desired diameter based on the length and the
power consumption.
FILTERING, RECOMMENDED AMPLIFIER SETTINGS
The correct choice of amplifier, its settings, filtering and enclosure
largely influence on the lifespan of your audio system. You should select an
amplifier with a nominal ower, not exceeding the nominal power of the
speakers. Proper coordination of the head unit (HU) with the amplifier will
allow to get a clean, undistorted signal applied to he component to prevent
overheating and voice coil damage. Recommended settings of the amplifier and
HU: Volume of HU should not exceed 80%. The amplifier sensitivity should be
set to 50%.
The recommended filter settings:
The high pass filter HPF (the filter that cuts all frequencies below those set
for the filter) should be set to 150-250 Hz (24 dB/Oct), or 250-350 Hz (12
dB/Oct) The low pass filter LPF (the filter that cuts all frequencies above
those set for the filter) should be set to 8-12 kHz (12 dB/Oct)ecommended
amplifiers: AAB-600.2D ATOM, AAB- 00.2D ATOM, AAB-300.4D ATOM, AAB-400.4D
ATOM, AAK-1600.2, AAK-220.4D, AAB-1200.2D, AAB-1800.2D, AAB-500.4D,
ARU-3000/2, AHL-300.4, AHL-200.4.
SPECIFICATIONS
| Model | AP-M67AC |
|---|---|
| Size (Inch) | 6.5 |
| Surround material | Cloth |
| Cone material | Pressed paper |
| Frame material | Aluminum |
| Magnet type | Ferrite |
| Power RMS (W) | 300 |
| Power MAX (N) | 600 |
| Voice coil size (Inch) | 1.75 |
| Voice coil wire | CCAW |
| Frequency response (Hz) | 100 – 12 000 |
THLELE – SMALL PARAMETERS
| Impedance (Ohm) | 4 |
|---|---|
| Sp! (dB) | 102. |
| Fs (Hz) | 110 |
| Vas (L) | 5. |
| Qts | 0.32 |
| BL | 10. |
This specified sensitivity is not directly connected with the sound pressure in the vehicle, and therefore should not be used as the sole indicator for comparison with other speakers.
DIMENSIONS
Connection of terminals
installtion
BOX CONTENTS
- Mid-range speaker – 2 pes.
- Owner’s manual – 1 pc.
- Warranty card – 1 pc.
- Window decals -2 pcs.
WARRANTY AND MAINTENANCE INFO0:
Deaf Bonce products are warranted against defects concerning materials and
their manufacturing under normal functioning conditions. While the product is
under warranty, defective parts will be repaired or replaced at the
manufacturer’s decision.
The defective product, along with notification about it, must be returned to
the dealer from which it was purchased together with the warranty certificate
duly filled in, complete with the original packaging. If the product is no
longer under warranty, it will be repaired at the current costs. Our company
does not undertake any liability for damages due to transportation.
Our company does not take any responsibility for costs or loss of profit due
to the impossibility to use the product, other accidental or consequential
costs, expenses or damages suffered by the customer. Warranty according to
laws in force. For more information visit our website and carefully read
warranty card. The manufacturer reserves the right to change design and
specification without prior notice.
INFORMATION ON DISPOSAL OF THE ELECTRICAL AND ELECTRONIC EQUIPMENT (FOR THE
EUROPEAN COUNTRIES WITH SEPARATE WASTE COLLECTION).
Items marked “crisscrossed wheeled bin” are not allowed to be disposed of
together with usual household waste. These electrical and electronic products
should be disposed f in special reception centers, equipped for recycling
such products and components. For information about the location of the
nearest disposal/recycling spot and the rules delivery of waste please
contact your local municipal office. Recycling and proper disposal helps to
protect the environment and prevent harmful effects onhealth.
https://deafbonce.com/speakers/apocalypse-ap-m67ac
Manufacturer: Ningbo Sound Solution I&E Trading Co., Ltd D4
Made in China
Documents / Resources
|
APOCALYPSE AP-M67AC 600 Watt 6.5 Inch Mid-Range
Speakers
[pdf] Owner's Manual
AP-M67AC 600 Watt 6.5 Inch Mid-Range Speakers, AP-M67AC, 600 Watt 6.5 Inch
Mid-Range Speakers, Mid-Range Speakers, Speakers
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>