APOCALYPSE AP-W81A Mid-Bass Speakers Owner’s Manual
- June 5, 2024
- APOCALYPSE
Table of Contents
OWNER`S MANUAL
MID-BASS SPEAKER
AP-W81A
APOCALYPSE SERIES
INTRODUCTION
Thank you for purchasing this Deaf Bonce product! Our company is committed to
the creation of extremely loud sound systems with no loss of quality.
To ensure proper use, please carefully read through this manual before using
this product. It is especially important that you read and observe caution in
this manual. Please keep the manual in a safe and accessible place for future
reference
SAFETY INSTRUCTIONS
-
Fasten the speakers properly when installing them in the vehicle. If the component is disconnected during driving, it may cause serious damage to the passengers of the vehicle or another vehicle.
-
Before installing the components, if possible store the product in its original package to avoid accidental damage to the product.
-
Be careful when installing and dismantling the speaker! Do not let the speaker drop to avoid damage to its moving parts.
-
When working with tools follow safety rules.
-
Before the installation switch off the head unit and all other audio devices to avoid their damage.
-
Make sure that the location of the speaker does not hinder the proper operation of mechanical and electrical devices of the vehicle.
-
Do not install components in places exposed to water, excessive humidity, high or low temperature, dust, or dirt.
ATTENTION!!! The product may be operated from +5 °C (41F) to +40 °C (104F). In case of moisture condensation, let the product dry. -
When performing plumbing, drilling or cutting works with the car, make sure that there is no wiring, brake lines, fuel pipe, or other structural elements under the place of work. Follow the safety rules! Use protective glasses and gloves.
-
When stretching back the speaker cables make sure that they are not in contact with sharp edges or moving mechanical devices. Make sure that they are firmly fixed and protected over the entire length.
-
The diameter of the speaker cables must be selected in accordance with the length and applied power.
-
Never stretch the cables outside of the car and near the moving parts of the car. This can lead to the destruction of the insulating layer, short circuits,s, and fire.
-
To protect the cables use rubber gaskets if the wire passes through a hole in the plate, or other similar materials if it lies close to the parts exposed to heat
CAUTION!!! High sound pressure can damage your health!
Please use common sense when controlling volume
WIRING DIAGRAMS
Do not expose your amplifier to loads below the value predetermined by the
manufacturer.
Various examples of connection types are given on the pages below. Use these
examples to determine the required load impedance of your connection.
Serial connection of the speaker
Voice coil | Total impedance |
---|---|
4 Ohm х 2 MB | 8 Ohm |
Voice coil | Total impedance |
---|---|
4 Ohm х 3 MB | 12 Ohm |
Voice coil | Total impedance |
---|---|
4 Ohm х 4 MB | 16 Ohm |
Parallel connection of the speakers
Voice coil | Total impedance |
---|---|
4 Ohm х 2 MB | 2 Ohm |
Voice coil | Total impedance |
---|---|
4 Ohm х 3 MB | 1.33 Ohm |
Voice coil | Total impedance |
---|---|
4 Ohm х 4 MB | 1 Ohm |
Mixed connection between the speakers
Voice coil | Total impedance |
---|---|
4 Ohm х 4 MB | 4 Ohm |
CAUTION!!! High sound pressure can damage your health!
Please use common sense when controlling volume!
Selection of the diameter of speaker cables
Use the table below to select the desired diameter based on the length and the
power consumption.
FILTERING, RECOMMENDED AMPLIFIER SETTINGS
The correct choice of the amplifier, its settings, filtering, and enclosure
largely influence the lifespan of your audio system. You should select an
amplifier with a nominal power, not exceeding the nominal power of the
speakers. Proper coordination of the head unit (HU) with the amplifier will
allow getting a clean, undistorted signal to apply to the component to prevent
overheating and voice coil damage. Recommended settings of the amplifier and
HU: The volume of HU should not exceed 80%. The amplifier sensitivity should
be set to 50%.
The recommended filter settings:
The high pass filter HPF (the filter that cuts all frequencies below those
set for the filter) should be set to 70-100 Hz (24 dB/Oct)
The low pass filter LPF (the filter that cuts all frequencies above those
set for the filter) should be set to 600-800 Hz (12 dB/Oct)
Recommended amplifiers: AAK-180.4, AAK-201.4D, AAB-1200.2D, AAB-600.2D,
AAB-500.4D, AAB-400.4D, AAB-300.4D, ARU 3000/ , AHL-300.4, AHL-200.4
SPECIFICATIONS
Model | AP-W81A |
---|---|
Size (Inch) | 8 |
Surround material | Cloth |
Cone material | Pressed paper |
Frame material | Stamped Steel |
Magnet type | Ferrite |
Power RMS (W) | 250 |
Power MAX (W) | 500 |
Voice coil size (Inch) | 2 |
Voice coil wire | Copper |
Frequency response (Hz) | 70 – 5 000 |
THIELE-SMALL PARAMETERS
Impedance (Ohm) | 4 |
---|---|
Spl (dB) | 90.5 |
Fs (Hz) | 68 |
Vas (L) | 15 |
Qty | 0.55 |
BL | 7.7 |
This specified sensitivity is not directly connected with the sound pressure in the vehicle, and therefore should not be used as the sole indicator for comparison with other speakers.
DIMENSIONS
Connection of terminals
Installation
BOX CONTENTS
- Mid-bass speaker – 2 pcs.
- Owner`s manual – 1 pc.
- Warranty card – 1 pc.
WARRANTY AND MAINTENANCE INFO
Deaf Bonce products are warranted against defects concerning materials and
their manufacturing under normal functioning conditions.
While the product is under warranty, defective parts will be repaired or
replaced at the manufacturer’s decision. The defective product, along with
notification about it, must be returned to the dealer from which it was
purchased together with the warranty certificate duly filled in, complete with
the original packaging
. If the product is no longer under warranty, it will be repaired at the
current costs.
Our company does not undertake any liability for damages due to
transportation. Our company does not take any responsibility for costs or loss
of profit due to the possibility to use the product, other accidental or
consequential costs, expenses, or damages suffered by the customer. Warranty
according to laws in force. For more information visit our website and
carefully read the warranty card.
The manufacturer reserves the right to change design and specification without
prior notice.
INFORMATION ON DISPOSAL OF THE ELECTRICAL AND ELECTRONIC EQUIPMENT (FOR
THE EUROPEAN COUNTRIES WITH SEPARATE WASTE COLLECTION)
Items marked “crisscrossed wheeled bin” are not allowed to be disposed of
together with usual household waste. These electrical and electronic products
should be disposed of in special reception centers, equipped for recycling
such products and components. For information about the location of the
nearest disposal/recycling spot and the rules of delivery of waste please
contact your local municipal office. Recycling and proper disposal help to
protect the environment and prevent harmful effects on health.
https://deafbonce.com/speakers/apocalypse-ap-w81a
Manufacturer: Ningbo Sound Solution 184E Trading Co. Ltd
Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>