Daves DCUJKFBMW Jeep JK Stubby Rock Crawler Front Bumper Instructions
- June 7, 2024
- Daves
Table of Contents
Daves DCUJKFBMW Jeep JK Stubby Rock Crawler Front Bumper
Specifications
| Feature | Description |
|---|---|
| Design | Functional, simple-styling, low profile, high clearance |
| Installation | Direct replacement, no cutting or modifications needed |
| Compatibility | Designed to accept most popular winch brands |
FAQ
- Do I need to modify my Jeep to install this bumper?
- No, the bumper is a direct replacement and requires no cutting or modifications.
- Can I install this bumper myself?
- Yes, with the right tools and good mechanical skills, you can install the bumper yourself.
- What should I do before painting or powder coating the bumper?
- Mount the front bumper to ensure proper fit before painting or powder coating to avoid damage.
Our JK stubby front bumper is a functional, simple-styling, low profile, and high clearance design. The front bumper is easy to install with the right tools and good mechanical skills. It is a direct replacement of the factory bumper with no cutting or modifications. The bumper is designed to accept most popular winch brands.
Before you paint or powder coat, mount the front bumper to ensure that it fits properly without risking damage to your paint or powder coat.
INSTALLATION PROCEDURE
- Park Jeep on level surface.
- Remove the plastic lower air dam. Use a push-in retainer removal tool or a screwdriver to pop out the plastic retainers along the front edge and also underneath where it attaches to the crash bar.
- If your Jeep is equipped with factory fog lamps, reach behind the bumper and disconnect the wiring harness plugs from the lamps.
- Use a ratchet and an 18 mm socket to remove the 8 nuts that fasten the bumper to the frame.
- With the nuts removed, remove the front bumper from the Jeep.
- With the nuts removed, remove the front bumper from the Jeep.
- With the bumper removed, then you can remove the top bumper cover. You may be able to remove the plastic pin retainers with a Philips screwdriver. They may be frozen in and will have to be pryed up to be removed.
- If equipped with factory fog lights, those may be removed from the stock front bumper and install the new front bumper with the supplied mounting hardware.
- Install the bumper onto the frame. There are 8 threaded studs located on the inside/backside of bumper that will correspond with the mounting holes on the frame.
- NOTE: The bumper may fit tight due to the slight manufacturing variances from Jeep to Jeep. You may need a rubber hammer to tap the bumper into place.
- Install the flat washers and all metal lock nuts and tighten.
- If you installed the factory fog lights into the bumper, plug the harness back into the lights, and then secure the harness with zip ties (not included).
- If installing a winch, it can be installed at this time; mount fairlead to the mount.
- NOTE: Some fairleads may require different mounting hardware than provided.
- Fairlead mount gets sandwiched between winch and bumper.
- NOTE: Some longer winch mounting bolts may be necessary than the ones provided with your winch.
If installing the optional skidplate, refer to the skidplate instructions at this time.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>