ziso M3 Infrared Electronic Thermometer User Guide
- June 6, 2024
- ziso
Table of Contents
ziso M3 Infrared Electronic Thermometer
Introduction
Specification
- Accuracy: ± 0.2 degrees (34 – 45 ºC, place it in the operating environment for 30 minutes before use)
- Abnormal automatic alarm: flashing + “Di Di” sound
- Automatic measurement: measuring distance 5cm -10cm
- Screen: Digital display
- Charging method: USB charging or battery(18650 Li- ion).
- Install method: nail hook (optional), double-sided adhesive sticking, bracket fixing(optional)
- Environment temperature: 10ºC-40ºC (Recommended 15ºC∼35ºC)
- Infrared measuring range: 0 – 50 ºC
- Response time: 0.5s
- Input: DC 5V
- Net weight: 350g
- Dimension: 170 115 140mm
- Standby: About one week
- Counting capacity: 999
Status Description
-
Standby. The red dot in the bottom of the display lights up in turn. (Fig.1)
-
Insufficient power: The horizontal bar lights up in the middle of the display. (Fig. 2)
-
Normal temperature: Flashing green lights and alarm “Di”. (Fig. 3)
-
Abnormal temperature: Flashing red lights and alarm “Di Di”. (Fig 4)
-
Default (bod object mode)
“Lo”: Ultra-low temperature alarm. (Fig. 5)
“HI”: Ultra-high temperature alarm. (Fig .6)
Operation Instruction
-
Temperature measurement: Front of the thermometer and approach it within 5-10 cm. (Fig 7)
-
Mode switching : There is a small hole on the back of the device (Fig. 8).
You can use a 3mm diameter screwdriver to insert the hole and then press the button.
(1) Temperature unit: Press ‘mode switch hole’ then select “C” or “F” ( Fig.9, 10) C: Celsius F: Fahrenheit
(2) Mode: Long press mode switch hole for 3 seconds to switch the temperature measurement mode (Sur. surface mode, bod: object mode, Cou: counting mode)
-
install and replace battery
(1) Remove three screws
(2) Open the back base and install 18650 Li battery
-
install method