WLIVE ADSG019 Wood TV Stand Instruction Manual
- June 3, 2024
- WLIVE
Table of Contents
WLIVE ADSG019 Wood TV Stand
IMPORTANT INFORMATION IS READ CAREFULLY. KEEP THIS INFORMATION FOR FURTHER REFERENCE.
GENERAL GUIDELINES
- Please read the following instruction carefully and use the product accordingly.
- Please keep this manual and hand it over when you transfer the product.
- This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed.
NOTES
- Please follow the assembly instructions precisely and only use the product as intended.
- If an odor is present when first opening the package, please leave the unwrapped product in a shaded and ventilated area for a few days to air out.
- Prior to assembly, please check the product for defects or missing accessories. If any defects are found or accessories are missing, do not use the product as damage or injury may occur;
- Please contact us for assistance and replacement.
- It is suggested you regularly check the product’s bolts and connections to ensure safe use.
- Assemble the item on a soft flat and clean surface to avoid scratches and damage.
- It is recommended that two people assemble this product.
WARNINGS
- During assembly, keep parts and packaging materials away from children and pets as there could cause injury and are a potential choking hazard.
- Avoid sharp objects or corrosive chemicals to prevent damage to the product.
- Please open the item slowly and cautiously to avoid pinching your hands by metal joints, especially for children.
- If you have any further questions, please feel free to contact us by email or official website: : wlive-cs@devaise.com
- We will reply ASAP.
- Before installation, please make sure you have all the hardware, the serial numbers are properly labeled corresponding to the list, and the quantity is correct.
- Enjoy your new purchase!
EXPLODED DRAWING
PARTS
MINIX POSITION
REMARK
- Put a blanket under the board to avoid scratches or damage.
- Please do not screw too deep or A too shallow.
- If screws do not align with the holes, loosen the screw pointed in the picture slightly, adjust the length of the hinge until it is aligned, and then retighten the screw on the hinge.
Installation
FRONT
REMARK
Part 9 is shorter than part 8.
REMARK
Please make the groove on board 7 match with part D.
HINGE ADJUSTMENT
If the door do not appear square or aligned, loosen or tighten the appropriate screws on each case hinge as illustrated.
DEPTH ADJUSTMENT
Loosen the screw and screw B C( Do not lose the screw to the end), push the
hinge arm upwards or backward, and re-tighten the screw .
B
FOR-AND-AFT ADJUSTMENT
Adjust screw C to make the hinge move backward or forward to the ideal
place， then tighten screw C.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>