ALTEC HALO 60cm DISH User Guide
- June 6, 2024
- Altec
Table of Contents
HALO 60cm DISH
Quick Start Guide
To View the UEC website and access the latest documentation.
https://uec.com.au/halo-60cm-documents
-
Select a location for the ODU
• Pick an area on the roof of your mobile home
that will allow the ODU to be mounted as flat and level and strong as
possible.
With good support that will permit the dish, once fitted and raised, to have a full 360-degree rotation and elevation range.
• Mind the Direction of Travel. -
Mount the ODU
• Drill the
mounting holes and cable access holes to prepare the site for installation.
• Ensure that all screw fixings are covered with a sealant to ensure that there are no leaks into the RV. -
Mount the IDU
• Dry place
is required for IDU to be mounted.
• Drill the mounting holes prepare the site for installation.
-
Power cable
• Red:
Positive of battery(VBAT+)
Black: Cathode of battery(VBAT-)
Yellow : Ignition(+) -
Wiring diagram
-
Turn on system
• Turn On
Power The antenna system will retract to shut down position and enter into
Sleep Mode. The power consumption is very low. -
Deploy system
• Press
DEPLOY will deploy the system.
Then antenna will lock onto the target satellite automatically. -
One button to change the target satellite
• Press
Function key can change the target satellite which you want in the list.
• Wait for 3 seconds, the target satellite will be selected automatically and tracked by the antenna.
• And it will return to Normal Mode automatically at the same time. -
Stow system
• If you use
the ignition stow function you install at the vehicle, the system will
automatically shut down the dish on vehicle startup.
• OR press STOW. The antenna system will retract to shut down position.
• Before you drive, please confirm the dish is completely retract to shut down positio n.
-
Turn off system
• Press
Power can turn off the system.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>