URUAV UZ85 85mm 2S FPV Racing Drone User Manual
- June 6, 2024
- URUAV
Table of Contents
URUAV UZ85 85mm 2S FPV Racing Drone
Frame quick assembly diagram
Camera connection
Flight controller connection diagram
CrazybeeX FR V2.2
CrazybeeX FS V2.2
CrazybeeX PNP V2.2
Receiver bind procedure
URUAV UZ85 CrazybeeX FR V2.2 Bind procedure:
Make the on board receiver get into bind mode: For 3.5.7 version firmware Plug
USB and then press the bind button for 1 second , the Red LED on the top of
the flight controller will getting to be solid , this indicate the receiver is
in bind mode; For 4.0.x version firmware Plug USB and then connect betaflight
configurator and then move to CLI tab , type “bind_rx_spi” ,the Red LED on the
top of the flight controller will getting to be solid , the onboard receiver
is in bind mode; For 4.1.x or 4.2.x the bind code is “bind_rx”Make your Frsky
transmitter get into bind mode . If bind is successful the red LED will
starting to blink. The red LED wouldn’t blinking when binding with some new
ACCESS firmware frsky radio , but the bind is actual successful , need to go
to CLI command and type “save” to finish the binding .
URUAV UZ85 CrazybeeX FS V2.2 Bind procedure:
Make the on board receiver get into bind mode: For 3.5.7 version firmware
Press and hold the bind button for 1 second ,then plug USB, the Red LED at the
bottom of the flight controller will blinking fast , this indicate the
receiver is in bind mode; For 4.0.x version firmware Plug USB and then connect
betaflight configurator and then move to CLI tab , type “bind_rx_spi” ,the Red
LED at the bottom of the flight controller will blinking fast , the onboard
receiver is in bind mode; For 4.1.x or 4.2.x the bind code is “bind_rx”Make
your Flysky transmitter get into bind mode . If bind is successful the red led
will getting to be solid.
URUAV UZ85 CrazybeeX PNP version bind procedure based on different external
receiver .
We already pre-solder the receiver wire for SBUS receiver . IR1 pad is
inverted serial signal used for SBUS receiver RX1 pad is Non-inverted serial
signal for ibus/dsm2/dsmx receiver
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>