comfee Washing Machine Installation Guide
- June 6, 2024
- comfee
Table of Contents
Quick Installation Guide
Thank you so much for choosing Comfee’s appliances. We really appreciate your choice and would love to help you get started.
Unpacking
You’ll soon be enjoying your new appliance
This guide will help you get started, for full details, please refer to the instruction manual.
What’s in the box
Installation
Bringing it all together
Important : Before installing, please make sure there are rubber gaskets
inside the fittings at both ends of the water supply hoses. Missing rubber
gaskets can cause water leakage.
Install the Bottom Cover
Slide the bottom cover into the slots on the bottom surface of the unit as shown in the following figure. Fix it with two screws attached to the unit.
Connect the water hose
- Connect the ends of the water supply hoses to the HOT and COLD faucets. Use the Quick Connection Adaptor for connection to the COLD water faucet.
- Connect the ends of the water supply hoses to the water supply inlet connections at the back of the washer.
- Turn on the HOT and COLD water supplies and check all the water supply intake connections and the faucets for water leaks.
Connect the drain hose
The drain hose can be positioned in three different ways
Leveling your washer
See if the washer is level by checking the position of the tub or using a leveling gauge.
- Slide the washer into position.
- Open the lid of the washer, and pour water into the tub to just below the pulsator level.
- If the washer is level, the pulsator is positioned at the center of the washer as shown in the figure above right. If not, level your washer by turning the front leveling feet clockwise or counterclockwise as necessary.
Using your washing machine
Let’s get started
Running a test cycle
- Run a test cycle to check if your washer is properly installed.
The washer should not rock or vibrate excessively when water is supplied or when washing or spinning and should drain well during the spin cycle.
WARNING
If water leaks while water is being supplied or drained, check the water
connections. If the washer rocks and vibrates excessively, level your washer
again.
Troubleshooting
We are always here to help
If you require any technical guidance or find that your washing machine is not
operating as intended, a simple solution can often be found in the
Troubleshooting section of the Owner’s Manual.
Commonly seen error codes and solutions:
| Error Code | Description | Possible Cause | Solutions |
|---|---|---|---|
| El | Water is not supplied | 1. Water tap is not Check the water tap and open | |
| it fully | Check the water tap and open it fully | ||
| 2. Water inlet is blocked | Clean the valve filter with a brush | ||
| 3. Water inlet valve is broken | Replace the water inlet valve | ||
| E2 | Not draining | Drain-pipe is hung too high | Install the Drain-pipe as |
instructed
Drain valve is blocked| Unclog the drain valve
The drain pump filter is blocked| remove and unclog the drainage pump filter
E3| Lid open alarm| The top lid is open| Close the lid and press the ON/OFF
button
E4| Unbalance alarm| The washing machine foot is not balanced| Check if the
machine is level
Unbalanced load| Check if clothes are spread out evenly in the drum.
Restart the machine when the load is redistributed.
XX| Others| Others| Restart the machine. call the service line if the problem
still exists.
For further assistance, feel free to contact us at 1-866-646-4332 with the following information ready:
| Model No. | CLV16N2AMG |
|---|
Serial No.
(You can find it on xxx)|
Date of Purchase|
Problem|
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>