FANATEC Podium Mounting Brackets User Guide
- June 6, 2024
- FANATEC
Table of Contents
PODIUM
MOUNTING BRACKETS
Quick Guide
WHAT’S INCLUDED
- 2x Mounting Plates
- 2x Mounting Side Adapters
- 4x Mounting Arms
- 6x Torx countersunk bolts for mounting the Side Adapters M8x30mm (A)
- 4x Mounting bolts for the Podium Wheel Base M8x25mm (B)
- 4x Allen bolts for the Mounting Arms M8x65mm (C)
- 8x Allen bolts for mounting on Rennsport Cockpit/40x40mm aluminium profile M8x55mm (D)
- 8x Allen bolts for mounting on 80x40mm aluminum profile M8x105mm (E)
- 12x M8 Nut
- 24x Aluminium washers
MOUNTING
First, screw the Side Adapters to the Mounting Plates.
There are two fixed angle options, as well as a curved channel that allows for
fine adjustments.
Screw the Mounting Plates to the side panels of the Podium Wheel Base.
Assemble the enclosed distance rings between Podium Wheel Base and the
Mounting Plate.
IMPORTANT!
To prevent cosmetic damages, first, assemble the Mounting Plates to the Podium
Wheel Base!
Screw the four Mounting Arms to the Mounting Plates. Mount the Mounting Arms, with the angled side to the front, on the top and bottom of the Mounting Plate.
ON ALUMINIUM PROFILE
Squared notches allow the use of a 40mm aluminum profile.
Tighten the clamps using the screws provided: short screws for 40x40mm profile
and long screws for 80x40mm profile.
ON RENNSPORT COCKPIT V2
Slide the assembly on the tubes of the cockpit and tighten the clamps with the shorter screws provided.
Manufactured by
Fanatec® is a registered trademark of Endor AG Designed
and developed by Endor AG in Germany
E.ON-Allee 3 – 84036 Landshut – Germany
Telephone: +49 (871) 9221-122 Fax: +49 (871) 9221-221
Email: info.webshop@fanatec.com
Website: www.fanatec.com –
www.endor.ag
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>