WinBridge Voice Amplifier S619 UHF User Manual

Voice Amplifier

User Manual

S619 UHF

Function Illustration

Main Function Description

1. Power Switch/ Volume Control
2. Power Indicator
3. MP3 mode indicator
When the indicator shows blue light, the mode is Bluetooth or UHF. When the indicator shows green light, the mode is TF card or USB driver.
4. Previous
Long press “ ” for fast reverse, short press to go to previous music
5. Play/Pause
In playing music mode, short Press “ ” to pause and press again to play
6. Next
Long press “ ” the for fast forward, short press to go to next music.
7. Mode switch
After insert USB driver or TF card, short press “ M ” to switch the mode among USB driver/TF card/ Bluetooth/ UHF mode.
In playing music mode, long press “ M ” for 3 seconds to single song loop, and long press “ M ” for 3 seconds again for all loop.
8. TF card slot
9. USB slot(reading data only)
10. MIC slot(support wired MIC)
11. AUX slot
12. DC 5V charging slot
13. Charging indicator

U8 Pro Function Illustration

1. Pair Key
2. Head Bracket
3. Charging Indicator
4. Volume –
5. Volume +
6. DC 5V
7. Power Switch
8. Microphone head
9. Detachable Head Bracket

How to pair and use U8 wireless microphone

1. Turn on U8 wireless microphone with blue Light becomes constantly lights;
2. Turn on speaker, short press M button to switch to UHF model, then long press M button again for about 3 seconds to enter UHF pair mode with voice prompt: “ UHF is waiting for connection”, meanwhile, the blue light flashes;
3. Do a press on the small silicone wifi button on the mic until speaker: “ UHF is connected” , meanwhile, the blue light stop flashing, then your voice will be amplified.

HOW TO CHARGING MICROPHONE?

– Charging speaker with plug included. –

In charging status: the indicator shows red while charging;

Fully charged: the red indicator goes off after charged fully.

Noted:
Long press “ ” key on the U8 microphone or long press M button on the speaker will disconnect with speaker automatically. Please refer above steps to repair manually.

Noted:
In UHF mode, short press “+” or “-” button on the microphone will turn up/down volume.

Operation Description

1. How to amplify your voice
   Turn on speaker with power switch on the top of control panel, pair the speaker and the U8, then you could amplify your voice.

2. How to play music via TF card/ USB driver
   Insert TF card / USB driver into corresponding slot, speaker will play music automatically; Press “ ” , “ ” to previous or next song
   Noted:
   TF card or USB driver is NOT included;

3. How to play music via AUX input
   Connect speaker to external audio device (with 3.55mm audio output like computer) via audio cable included;

How to connect with Bluetooth

1. Click “ M ” to switch to Bluetooth mode, the MP3 mode indicator shows blue light, and there will a voice prompts: Bluetooth is waiting for connection.
2. Turn on the Bluetooth device and search name “ S619 ” to pair.

How to charge speaker

Please turn the speaker off and charge it timely when it is in low battery with voice prompts “Low battery, please charge”. The red indicator light is always on when charging, and the red indicator light is off when fully charged.

Please note:

1. Use the included DC 5V power adapter to charge the speaker internal rechargeable battery.
2. Plug adapter into 110~240 AC outlet. Connect the cable end into the DC 5V power input on speaker.
3. It will normally take 3-5 hours to fully charge the battery.
4. When charging is required, a voice prompt will indicate, “Low battery, please charge”, the battery indicator will blink while charging. It will stop blinking when battery is fully charged.
5. Recharge the battery within 48 hours of “low battery” voice prompt. In order to extend the life of the internal battery, please charge it regularly even if system is not being used.
6. It is suggested that you charge the internal battery an additional 1-2 hours after fully charged to extend its life.
7. Please DO NOT over charge the battery by leaving the system plugged in continuously. This will reduce the life of the internal rechargeable battery and could cause over heating.

Specifications

  How to wear voice amplifier unit:

Package included:

• 1*speaker
• 1*headset microphone
• 1*waistband
• 1*DC 5V adapter
• 1*charging cable
• 1*audio cable
• 1*user manual

After-sale service

WinBridge provides one year warranty and lifetime technical support.
  [email protected]
http://www.winbridgepower.com

Please be confident that seller support is just a mail away from you in case you find any difficulty. Kindly do not hesitate to write back to us if you need any clarification or any kind of support.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>