IKEA 203.426.58 TRADFRI Drive for Wireless Control Instructions

June 6, 2024
Ikea

TRÅDFRI
IKEA 203.426.58 TRADFRI Drive for Wireless Control

ATTENTION: CAUTION:

Injury to persons and damage to the lamp and/or the mounting surface may result if the lamp is pulled from the surface. To reduce the likelihood of such injury or damage, mount only on a surface that is mechanically sound.

WARNING

Deviation from the assembly instructions may result in a risk of fire or electric shock.
English This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation.

WARNING

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CAUTION

To reduce the risk of fire, electric shock, or injury to persons: Use only insulated staples or plastic ties to secure cords. Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall. Position the portable cabinet light with respect to the cabinet so the lamp replacement markings can be read during relamping. Not intended for recessed installation in ceilings, or soffits. The low-voltage portable cabinet light may be installed inside or under a kitchen cabinet or other built-in furniture when:

  1. The low-voltage Class 2 power supply is located outside the cabinet and is not concealed; and
  2. The line voltage power supply cord is not concealed or run through openings in the cabinet, walls, ceilings, or floors. This requirement does not apply to the wiring between the cabinet light and the power unit. The National Electric Code (NEC) does not permit cords to be concealed where damage to insulation may go unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any damage is noted.

MX
importador/Distribuidor: IKEA Supply Mexico, S.A. de CV., Av. Paseo de las Palmas 275, Int. 403-404, Lomas de Chapultepec V section, Miguel Hidalgo C.R: 11000 Ciudad de Mexico, Mexico, Tel. 800-1-4532 69. Lea y siga todas las instrucciones de seguridad y operation antes de usar este producto/Para use Interior/Consulte Especiflcaclones electricas en el etiquetado del producto.

IKEA 203.426.58 TRADFRI Drive for Wireless Control -
Fig

1
IKEA 203.426.58 TRADFRI Drive for Wireless Control - FIg
2IKEA 203.426.58 TRADFRI Drive for
Wireless Control - FIg 5

You can connect up to 10 drivers in one installation, using the intermediate connection cord in between. You can connect up to 9 lighting units to the 30W driver, as long as the total wattage does not exceed 30W.

The power supply cord, intermediate connection cord, and steering device (e.g. remote control) are sold separately. If you want to use more than one (1) driver, pair each with the steering device, so that the entire combination can be turned on and off or dimmed at the same time.

IKEA 203.426.58 TRADFRI Drive for Wireless Control - FIg
6IKEA 203.426.58 TRADFRI Drive for
Wireless Control - FIg 7

© Inter IKEA Systems B.V. 2017
2020-07-16
AA-2056562-4

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals