Shark IZ462H DuoClean PowerFins Cordless Vacuum with Self-Cleaning Brushroll User Guide
- June 6, 2024
- Shark
Table of Contents
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
POWERFINS
DuoClean® PowerFins Cordless Vacuum with Self-Cleaning Brushroll
QUICKSTART GUIDE
IZ462H
For questions, visit us online atsharkclean.com
WHAT’S INSIDE:
A Handheld Vacuum
B MultiFLEX® Wand
C DuoClean® PowerFins Floor Nozzle
D Crevice Tool
E Pet Multi-Tool| F Anti-Allergen Brush
G Lithium-Ion Battery (Pre-Installed)
H Charger
I HEPA Post-Motor Filter (Pre-Installed)
---|---
ASSEMBLY
For additional parts and accessories, visit sharkclean.com
POWER SETTINGS
OFF
Slide switch to the top to turn off the power.
To begin vacuuming, slide switch to the appropriate setting.
HARD FLOOR SETTING
Slide switch to the middle. The brush rolls spin slowly to clean hard floors
and low-pile area rugs.
CARPET SETTING
Slide switch to the bottom. The brush rolls spin faster to pick up debris
below the surface of your carpets.
BOOST MODE
For an added boost in power, pull the Trigger on the handheld vacuum.
Release it to return to standard power.
LITHIUM-ION POWER PACK
In Use
|
Charging
---|---
| 
Battery Indicator Lights
NOTE: The Lithium-Ion PowerPack battery comes partially charged. Charge
fully before first use, then run the battery down until it is completely out
of power. This will condition the battery so the LED indicators will work
properly.
CHARGING
To put the vacuum in storage mode, press the MultiFLEX Lock Release
button while folding the handheld vacuum forward until the wand clicks and
locks. Plug the charger
into the charging port on the battery.
To remove the battery, press the Battery Release button and slide out the battery. Plug the charger into the charging port on the battery.
REACH ANYWHERE
Press the MultiFLEX® Lock Release button to lower the angle of the wand to increase your reach.
STORE ANYWHERE
Press the MultiFLEX Lock Release button and fold the handheld vacuum forward.
To vacuum, lift up the handheld vacuum, until the wand locks in place.
EMPTYING THE DUST CUP
- To empty the dust cup, first, disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up the handheld vacuum.
- Position the dust cup over a trash bin and slide the lid release button forward.
©2020 SharkNinja Operating LLC.
DUOCLEAN, MULTIFLEX, and SHARK have registered trademarks of SharkNinja
Operating LLC.
VERTEX is a trademark of SharkNinja Operating LLC.
IZ462H_QSG_MP_Mv2