Shark SLIM UPRIGHT QU203Q Series User Guide
- June 6, 2024
- Shark
Table of Contents
Shark SLIM UPRIGHT QU203Q Series
WHAT’S INSIDE
Handle
Hose
Vacuum Pod
Wand
DuoClean® Floor Nozzle with Self-Cleaning Brushroll
Dusting Brush
Duster Crevice Tool
Pet Power Brush
ASSEMBLY
❶ Place pod onto motorized floor nozzle.
❷ Insert wand into top of pod.
❸ Insert handle into top of wand.
❹ Connect hose to back of pod.
❺ Store accessories on the posts on the pod.
IMPORTANT: For proper operation, ensure all connections are securely clicked into place.
For additional parts and accessories, visit sharkaccessories.com
2 WAYS TO CLEAN
UPRIGHT
Power
Push the POWER button to turn the vacuum on or off.
Brushroll Operation
To engage the brushrolls, turn on the power, step on the floor nozzle, and
tilt the handle back.
To clean carpeted floors, press CARPET on the surface selector switch. The brushrolls spin quickly in this mode.
To clean bare floors, press HARD FLOOR on the surface selector switch. The brushrolls will spin slowly in this mode.
ABOVE THE FLOOR
For complete instructions, see the enclosed Owner’s Guide.
MAINTENANCE
Empty dust cup after each use
Filter Maintenance
Wash filters regularly to keep the suction strong.
Rinse filters with water only, and allow them to air-dry before reinstalling.
Tap loose dirt from filters as needed between washes.
See enclosed Owner’s Guide for complete details on removing and cleaning
filters.
Self-Cleaning Brushroll
NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow the self-cleaning brushroll to remove it for you. If some fibers remain wrapped around brushroll after continued use, open the brushroll garage lid and carefully remove them
Cleaning the Brushroll
- To open the brushroll garage, slide both release buttons on the floor nozzle away from you, towards the back of the nozzle, then lift off the lid.
- Clear away any objects or debris.
- To close the brushroll garage, insert the 3 tabs on top of the lid into the 3 slots in the nozzle, then push down on both sides of the lid until it clicks securely into place. If the Brushroll Indicator Light isn’t green and headlights are flashing, check again that both sides of the lid are locked in place.
Brushroll Maintenance
Carefully remove any debris that may be impeding the brushroll.
Cleaning the Soft Roller
Open the brushroll garage lid, then lift out the Soft Roller by pulling the
tab on the right side. Clear away any debris, then slide the Soft Roller back
into place.
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
To register your product, or for answers to frequently asked questions, visit registeryourshark.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>