Shark QZ162HQ Cordless Vacuum User Guide
- June 6, 2024
- Shark
Table of Contents
ROCKET® PRO
CORDLESS VACUUM
QUICKSTART GUIDE
QZ162HQ
Please make sure to read the enclosed Shark® Owner’s Guide prior to using your
vacuum.
For questions, visit us online at
sharkclean.com/support
Register your vacuum at registeryourshark.com
WHAT’S INSIDE:
ASSEMBLY
A Handheld Vacuum
B Dirt Engage™ Floor Nozzle
C MultiFLEX® Wand
D Pet Multi-Tool| E 8″ Crevice Tool
F Charger
G Li-Ion Battery (Pre-Installed)
H HEPA Post-Motor Filter (Pre-Installed
---|---
For complete maintenance instructions, see the enclosed Owner’s Guide.
For additional parts and accessories, visit
sharkaccessories.com.
For additional batteries and charging accessories, visit
sharkclean.com/batteries.
POWER SETTINGS
OFF
Slide switch to
the top to turn off the power. To begin vacuuming in Standard Mode, slide
switch to the appropriate setting.
BARE FLOOR SETTING
Bare
Floor/Area Rugs Slide switch to the middle. The brush roll spins slowly to
clean bare floors and small area rugs.
CARPET SETTING
Carpet
Slide switch to the bottom. The brush roll spins faster to pick up debris
below the surface of your carpets.
BOOST MODE
For an
added boost in power, pull the Trigger on the handheld vacuum. Release it to
return to standard power.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please
select the Carpet setting and pull the trigger to go into Boost mode.
NOTE: Select Carpet setting for stuck-on dirt and debris.
CHARGING
Easily Insert or Remove the Li-Ion Battery
To insert, slide the battery into the slot in the back of the handheld vacuum.
To remove, press and hold the Battery Release Button then slide out the
battery.
LI-ION BATTERY
In Use
Charging
NOTE: Full charge takes approximately 3 hours.
NOTE: The battery comes partially charged. Charge fully before first use.
Battery Runtime
| MODE | MINUTES |
|---|---|
| Hand Vac | 40 |
| Bare Floor/Standard Mode | 25 |
| Carpet Mode/Standard Mode | 20 |
| Boost Mode (Hand Vac) | 10 |
MULTIFLEX® REACH
Press the MultiFLEX Lock Release button to lower the angle of the wand to increase your reach.
MULTIFLEX STORAGE
To store, press the MultiFLEX Lock Release button and fold the handheld vacuum
forward.
To vacuum, lift up the handheld vacuum by pressing the MultiFlex Lock until
the wand locks in place.
EMPTYING THE DUST CUP
- To empty the dust cup, first, disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up the handheld vacuum.
- Position the dust cup over a trash bin and slide the CleanTouch™ Dirt Ejector forward.
© 2020 SharkNinja Operating LLC. SHARK and ROCKET are registered trademarks of
SharkNinja Operating LLC. CLEAN TOUCH, DIRT ENGAGE, and MULTIFLEX are
trademarks of SharkNinja Operating LLC.
QZ162HQ_QSG_REV_Mv2
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>