ILFORD SPRITE 35-II User Manual
- June 6, 2024
- ILFORD
Table of Contents
ILFORD SPRITE 35-II
For product specifications and warranty information visit
–www.ilford.com
ILFORD and the ILFORD Logo are registered trademarks of ILFORD Imaging Europe
GmbH.
HOW TO LOAD FILM
Press the latch (A) in the direction of the arrow and open the camera back
door (B). Lift the camera rewind crank (C) and place a new roll of film into
the chamber.
Push the rewind crank (C) back into place. Pull out the film canister and hook
the 2nd hole onto the film take-up spool (D). Slightly advance the film by
turning the film advance wheel (E).
Ensure the film lays flat against the centre of the camera and close the back
door.
Continue to advance the film by turning the film advance wheel (E) until it stops. Press the shutter button. Repeat the process one more time. The film counter (F) will now show number ‘1’, and the camera is ready for taking pictures.
HOW TO SHOOT PHOTOS
For best results, stand at least 1 metre from the subject and take photos in
sunny or partly sunny weather. When taking pictures, keep the sun at your
back.
After all the pictures are taken press the rewind button (G) located at the
bottom of the camera. Turn the film rewind crank (C) clockwise until all the
film is re-wound back into the film canister.
Open the camera back door (B). lift up the film rewind crank (C), and remove
the film for processing.
HOW TO INSERT BATTERY (FLASH)
Open the battery door in the direction of the arrow. Insert one “AAA” battery
into the battery chamber. Make sure the battery is inserted according to the
correct polarity (“+” “-”).
HOW TO USE FLASH
Switch the flash Button to the “ ” position. Wait for the Flash Ready LED to
glow. Once the Flash Ready Light glows, the flash is ready for taking
pictures.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>