tc electronic 000-DDL00-00010 Sentry Noise Gate Electronic Pedal User Guide
- June 6, 2024
- tc electronic
Table of Contents
Quick Start Guide
SENTRY NOISE GATE
Visit tcelectronic.com to download the full manual
SENTRY NOISE GATE
Controls
- USB – Connects to your computer for firmware updates and TonePrint editing.
- Gate type selector – Selects between a traditional single band gate (up), a custom TonePrint (middle), or a multi-band hard gate ideally suited for hiss elimination (down).
- Damp – Adjusts how much attenuation is applied to the signal once it falls below the threshold.
- Send
- Output
- Footswitch – Turns the effect on and off.
- Power – Connect a 9 V / >100 mA power supply.
- Threshold – Determines the level below which the gate will start attenuating the signal.
- Decay – Adjusts how quickly the signal is attenuated after dropping below the threshold.
- Input
- Return
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
TC Electronic
SENTRY NOISE GATE
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 5270 Procyon Street, Las Vegas NV 89118, United States
Phone Number: +1 702 800 8290
SENTRY NOISE GATE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant o part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by MUSIC
Tribe can void the user’s authority to use the equipment.
Hereby, Music Tribe declares that this product is in compliance with Directive 2014/30/EU, Directive 2011/65/EU and Amendment 2015/863/EU, Directive 2012/19/EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S Address: Ib Spang Olsens Gade 17,
DK – 8200 Aarhus N, Denmark
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>