MEGA LITE Mega Splitter Universal 2×4 DMX Splitter User Manual

MEGA LITE Mega Splitter Universal 2×4 DMX Splitter User Manual

Safety Information

Check that the unit has not been damaged during transport

Protection Against Fire

Fire

1. Maintain a minimum of 2 foot distance from any type of flame.
2. Replace fuse only with the specified type and rating.
3. Do Not install the unit to close to a heat source.
4. Make sure cable are properly secured.
5. Maximum surface operating temperature 80ºC.

Protection Against Fire

Electrical

1. Disconnect power before servicing.
2. For connection to main power supply proceed to page 5.
3. This unit must be earthed. (electronically grounded)
4. This product is intended for indoor use only.
5. To prevent risk of fire or shock , do not expose fixture to rain or moisture.

Protection Against Mechanical Hazards

Mechanical

1. Use quality clamps or bolts when positioning unit.
2. Do not open unit while it is on, risk of electrical shock.

Specifications

Part Numbers

• Fixture: MC1060– Mega Splitter

Mechanical Specifications

• Input DMX Connections: Front and Rear 3-pin & 5 Pin XLR connectors
• Output DMX Connectors: 4 output / 3-pin & 5 Pin XLR connectors
• Power Connection: IEC power connection to Edison
• Fastening System: 1U Rack Mountable Front or Back & wall mountable

Electrical Specifications

• Electronic isolation between input & output
• Electronic isolation between output and output
• Terminator button for last unit
• Power indicator
• Signal indicator
• Power Consumption: 110V-60 Hz

Main Power Connection

Caution!

1. Do not connect fixture to a dimmer system.
2. This unit must be earthed. (electronically grounded)
3. Replace fuse only with the specified type and rating.

The occupation of the connection-cable is as follows:

110V Connection

Cable (USA)

| Cable (EU)| Pin| Connection
---|---|---|---
Black| Brown| Live|

L

White

| Light Blue| Neutral| N
Green| Yellow/Green| Ground|

DMX-512 Connection

The Mega Splitter is a DMX signal amplifier and distributor. The unit allows you to split a DMX signal into four separate signal outputs. Also it boost your DMX signal for extensive cable runs between DMX lighting fixtures.

• DMX—input
  

• DMX—output
  
  

1

| Shield
---|---
2|

Signal (-)

3

| Signal (+)
4|

Not Used

5|

Not Used

Installation

The Mega Splitter can be rack mounted from the front or back or wall mounted. For wall mount, remove the rack ears on the front panel and screw them on the side panels. For rear mounting remove the rack ears from the front and mount them on the rear panels

Operation

1. Connect DMX out from your DMX controller (you can use ether the 3 or 5 Pin XLR connection) to your DMX in of the Mega Splitter You can use the Input from the front or the rear.
2. Use the four output channels to send DMX signal to your DMX fixture. (You can use ether the 3 or 5 pin XLR connection).
   

Cleaning and Maintenance

Installation Maintenance: The operator has to make sure that the unit is operating safely and has the installations and electronics checked by an expert every 2 years.

The following points have to be considered during the inspection:

1. All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.
2. There must not be any deformations on the housing, fixation and installation spots (ceiling, suspension, trussing).
3. The power supply cables must not show any damages, material fatigue (e.g. porous cables) or sediments. Further instructions depending on the installation spot and usage have to be adhered by a skilled installer and any safety problems have to be removed.

Caution Danger to life!

Electrical

Note: There is no serviceable parts inside the device except for the LED’s. Maintenance and service operations are to be carried out by authorized dealers.

Replacing the fuse: Only replace the fuse with the same type and rating.

Replacing the power cable: If the power cable of this device becomes damaged, it has to be replaced by authorized dealers only

Should you have further questions , please contact your dealer.

Parts List

MC1060-mpcb

| Main PCB Card
---|---
MC1060-ts|

Terminator Switch

MC1060-ps

| Power Switch
MC1060-pc|

Power Connection

MC1060-xlr3m

| 3 Pin XLR Male
MC1060—xlr3f|

3 Pin XLR Female

MC1060-xlr5m

| 5 Pin XLR Male
MC1060-xlr5f|

5 Pin XLR Female

Warranty Information

Warranty Conditions

• Unless otherwise stated in writing, your product is covered by a one year parts and labor limited warranty.

• LED’s and LAMPS are not guaranteed to match in color or output.

• It is the owner’s responsibility to furnish receipts or invoices for verification of purchase, date, and reseller or distributor.
  If purchase date cannot be provided, date of manufacture will be used to determine warranty period.

• Goods returned under warranty must follow the proper authorization procedure and must be accompanied by a copy of the original invoice.

• Goods repaired under warranty will be returned to the owner with the freight prepaid by MSI via the most economical means of shipment.

• Repair or replacement as provided for under this warranty is the exclusive remedy of the consumer. MEGA SYSTEMS INC. makes no warranties, express or implied, with respect to any product, and Mega Systems specifically disclaims any warranty of merchantability or fitness for a particular purpose. Mega Systems shall not be liable for any indirect, incidental or consequential damage, including lost profit, sustained or incurred in connection with any product or caused by product defect or the partial or total failure of any product regardless of the form of action, whether in contract, tort (including negligence), strict liability or otherwise, and whether or not such damage was foreseen or unforeseen.

• Warranty is void if the product is misused, damaged, modified in any way, or for unauthorized repairs or parts. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Customer Support

Mega Lite has a customer support line to provide set up help and to answer any question should you encounter a problem. Please visit our website for any other related technical documents. For service related issue please contact our
service dept.

Monday—Friday 9am to 6pm CST
Voice: 210-684-2600
E-mail: service@mega.lighting

Mega Lite
18668 Highway 16N
Helotes, Texas 78023
Ph 210-684-2600
Fax 210-855-6279
Web: www.mega.lighting
Email: info@mega.lighting

Manual Version

Please Visit www.mega.lighting for the most up to date manual version

References

• Concert Touring Lighting | Lighting Consoles - MEGA-LITE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>